LG GSL325WBYV, GSL325WBQV, GSL325PVQV User Manual

MFL67683082

www.lg.com

(In the UK Only)

Electrical Connections

Important

The wires in this mains lead are coloured in accordance with the following code:

GREEN AND YELLOW:EARTH

BLUE:NEUTRAL

BROWN:LIVE

This appliance must be earthed

Green and Yellow (Earth)

Brown(Live)

Blue(Neutral)

As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:

The wire which is coloured Green and Yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol( ) or coloured Green or Green and Yellow.

The wire which is coloured Blue must be connected to the terminal which is marked with the letter N or coloured Black.

The wire which is coloured Brown must be connected to the terminal which is marked with the letter L or coloured Red.

If a 13 amp(BS 1363) plug is used, t a 13 amp BS 1362 fuse.

Fuse

Cord grip

Shelf

Deodorizer

Freezer compartment

It is normal...

Don’t use an

extension cord

Accessibility

of Supply Plug

Supply Cord

Replacement

Warning

Introduction

Entry

The model and serial numbers are found on the inner case on the back

or one side of the refrigerator

are unique to this unit and are not available to others. You should record requested information here and retain this guide as a permanent record of your purchase. Staple your receipt here.

Date of purchase : Dealer purchased from : Dealer address : Dealer phone no. : Model no. : Serial no. :

Important safety instructions

Before it is used, this refrigerator must be properly installed and located in accordance with the installation instructions in this document. This Refrigerator is intended for Domestic indoor use only.

Never unplug your refrigerator by pulling on the power cord. Always grip plug rmly and pull it straight out from the outlet.

When moving your appliance away from the wall, be careful not to roll over the power cord or to damage it in any way.

After your refrigerator is in operation, do not touch the cold surfaces in the freezer compartment, particularly when your hands are damp or wet. Skin could adhere to these extremely cold surfaces.

Unplug the power cord from the power outlet for cleaning or other maintenance. Never touch the appliance with wet hands as you may receive an electric shock or injure yourself.

Never damage, press, severely bend, pull or twist the power cord as damage to the cord may cause re or electric shock. Never touch the cord if you are uncertain if the appliance is correctly earthed.

Never place glass items in the freezer as they may break due to expansion of their contents on freezing.

Never put your hands into the storage bin of the automatic ice maker as you could be injured during its operation.

The appliance is not intended for use by young children or inrm persons without supervision.

Young children should be supervised to ensure that they do not play with the appliance. Never allow anyone to climb, sit, stand or hang on the refreshment centre door. These

actions may damage the refrigerator and even tip it over, causing severe personal injury. It is advised that this appliance should be connected through an independent power

socket to prevent it and other appliances from overloading the circuit and causing a power outage.

The appliance should be positioned so that the supply plug is easily accessible for quick disconnection should an accident occur.

If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualied person in order to avoid a hazard.

Do not modify or extend the Power Cord length.

It may cause electric shock or re.

compartment of this unit. These numbers

Introduction

Child entrapment

Warning

Don’t store

Warning

Grounding

(Earthing)

Warning

DANGER: Risk of child entrapment. Before you dispose of your old refrigerator please remove doors but leave the shelves

in place so that children cannot climb inside. This appliance is not intended for use by persons (including children) with reduced

physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance.

this or any other appliance. In the event of an electric short circuit, grounding (earthing) reduces the risk of

electric shock by providing an escape wire for the electric current. In order to prevent possible electric shock this appliance must be earthed. Improper

electrician or service engineer if the earthing instructions are not completely understood, or if you have doubts as to whether the appliance is properly earthed. Do not use the combustible spray near the refrigerator. Do not store explosive substances such as aerosol cans with a ammable propellant in this appliance. It may cause re.

Keep ventilation openings in the room where the appliance is installed clear of obstruction.

Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.

Do not damage the refrigerant circuit. Do not use electrical appliances inside the food storage compartments of the

appliance, unless they are of the type recommended by the manufacturer. Disposal procedures. If disposing of this appliance, please consult with a service

This appliance may contain (Check the rating/comliance label for the refrigerant type and amount. Applicable to some models only) a small amount of isobutane refrigerant (R600a), natural gas with high environmental compatibility, but it is also combustible. When transporting and installing the appliance, care should be taken to ensure that no parts of the refrigerating circuit are damaged. Refrigerant squirting out of the pipes could ignite or cause an eye injury. If a leak is detected, avoid any

appliance is standing for several minutes.

refrigerating circuit occurs, the size of the room in which the appliance may be sited depends on the amount of refrigerant used. The room must be 1m

in size for every 8g of R600a refrigerant inside the appliance. The amount of refrigerant in your particular appliance is shown on the identication plate inside the appliance. Never start up an appliance showing any signs of damage. If in doubt, consult your dealer.

*Non dispenser model

Introduction

Dairy corner

NOTE

• Parts, features, and options vary by model. Your model may not include every option.

Introduction

*Dispenser model

Dairy corner

NOTE

• Parts, features, and options vary by model. Your model may not include every option.

Select a good

location

Installation

Where to install

1. Place your appliance where it is easy to use.

2. Avoid placing the unit near heat sources, direct sunlight or moisture. Do not operate the appliance outdoors where it can be exposed directly, or indirectly to sun, wind and rain.

3. To ensure proper air circulation around the

space on both the sides as well as top and maintain at least 2 inches (5 cm) from the rear wall.

4. To avoid vibrations, the appliance must be levelled.

5. Do not install the appliance in temperatures of less than 5°C as the performance may be

Disposal of the

old appliance

Door removal

Remove lower

cover and then

feed water

tube

Remove the

freezer

compartment

door

als which are reusable and/or recyclable. All the packaging materials should be sent to the collection centre for recycling. For details of your local recycling centre, please contact your local council.

Electric Shock Hazard Disconnect electrical supply to refrigerator before installing. Failure to do so could

result in death or serious injury. If your front door is too narrow to get

Applicable to No Plumbing

Ice & Water Model only

the refrigerator into the house, remove the refrigerator doors and pass the appliance through laterally.

Lower cover

Remove the lower cover by loosening all the screws. Then push in the feed water tube while depressing the connector , as shown in the illustration

Feed water tube

on the right.

NOTE

• If a tube end is deformed or abraded, trim the end with sharp knife until perfectly round.

1) Remove the hinge cover by loosening the screws. Then sepa-

Hinge cover

Connection wires

rate all connection wires except for the earth.

2) Remove the keeper by rotating it counter clockwise ( ) and then lifting the upper hinge up ( ).

①

②

Upper hinge

Keeper

Earth line

Upper hinge

NOTE

• When removing the upper hinge, be careful that the door does not fall forwards .

Installation

3) Remove the freezer compartment door by lifting it upward. The door should be lifted high enough for the feed water pipe tube to be completely pulled out.

Lower cover

NOTE

• If you have removed the refrigerator compartment door to pass the appliance through an access door, lay the door down, but be careful not to damage the feed water pipe tube.

water feed pipe tube to be completly pulled out

Enough for

Remove the

refrigerator

compartment

door

Pass the

ator

refriger

1) Loosen the hinge cover screws and remove the cover. Remove connection wires, if any, except for the earth line.

Connection

2) Remove keeper by rotating it clockwise ( ) and then remove the upper hinge by lifting it up ( ).

①

②

3) Remove the refrigerator compartment door by lifting it up.

Pass the refrigerator laterally through

the access door as illustrated to the right.

wires

Upper hinge

Keeper

Lower hinge

Door replacement

Once the fridge is through the access door, remount the fridge doors by following the door removal instructions in reverse.

installation

Warning

compartment

door is lower than

compartment

door

Installation

Feed water pipe installation (Dispenser model only)

erofeB

rezeerf eht fI

rotaregirfer eht

▪Automatic ice maker operation needs water pressure of 147~834kPa

(1.5~8.5kgf/cm2) (The pressure is correct when an instant paper cup (180cc) is

▪If water pressure does not reach the rating 147kPa(1.5kgf/cm2) or below, it

is necessary to purchase a separate pressure pump for normal automatic icing and cool water feed.

▪Keep the total length of the feed water pipe tube within 8m and be careful that

the tube does not bend. If the tube is 8m or longer it may cause water feed problems owing to the drain water pressure.

▪Install the feed water pipe tube at a place free from heat. ▪

Door height adjustment

Levelthedoorbyinsertingﬂat(-type)driverintothegrooveoftheleftheight adjustingscrewandrotateitclockwise().

①

Height

compartment

door is higher than

compartment

door

Left height

adjustment screw

rezeerf eht fI

Levelthedoorbyinsertingﬂat(-type)driverintothegrooveoftheleftheight adjustingscrewandrotateitclockwise().

①

rotaregirfer eht

Height

Right height

adjustment screw

Installation

zer eerfeht fI

compartment

door is lower than

the ref or taregir

compartment

door

(on some model)

zer eerfeht fI

compartment

door is higher than

ref or taregireht

compartment

door

(on some model)

Insert the transparent sheet supplied with the product wen the freezerdoor is lower then the refrigerator door

Separate the door with the lower height, use the (+) type screwdriver to unscrew the screw at the bottom hinge as shown at Figure ( ), insert the transparent sheet

as shown at Figure ( )

Make adjustments when the refrigerator door is lower then the freezer door while using the refrigerator.

Use the adjustment tool ( ) to rotate the adjustment hinge pin ( ) in either clockwise or counterclockwise direction to level the height of the refrigerator to that of the freezer.

②

①

②

Warning

After levelling

the door height

Do not adjust the height axcessively. You can lose the hinge pin. Height adjustable range: Maximum of 5mm)

Therefrigeratordoorswillclosesmoothlybyadjustingthefrontsideusingthe

height adjustment screw. If the doors do not close correctly, performance may be

thoroughly.

2. Install accessories such as the ice cube box, cover evaporating tray, etc., in their proper places. They are packed together to prevent possible damage during shipping.

3. Connect the power supply cord (or plug) to the outlet. Don’t double up with

other appliances on the same outlet.

+ 23 hidden pages