Before installing the drive, turn off
the system power.
Disconnect the power cord,
and remove the cover.
• Remove a vacant 5.25” drive bay panel from
the computer. Slide the drive into the drive
bay.
Set the jumper on the rear of
the drive as necessary.
A. When using a Primary IDE port
If you need to connect your drive to the same
primary IDE channel as the hard drive, the drive
should be set to SLAVE position.
B. When using a Secondary IDE port
❶ If there is no device connected to the
secondary IDE channel, connect the
drive to this channel and set the jumper
to MASTER.
❷ When two drives are connected, set one
drive to MASTER and the other drive to
SLAVE. If your operating system encounters
interface problems after installing the new
drive, try swapping the jumpers or move
one drive to another IDE channel.
Installing the Drive
Method A
Method B
D
IG
I
T
A
L
A
N
A
L
O
G
INTE
RFACE
PO
WER
D
R
C
S
M
S
L
A
G
L
G
3
9
1
+
5
+
1
2
G
N
D
4
0
2
A
U
D
I
OA
U
D
IO
Super Multi DVD Rewriter
Super Multi DVD Rewriter
D
IG
I
T
A
L
A
N
A
L
O
G
INTERFACE
POWER
D
R
C
S
M
S
L
A
G
L
G
3
9
1
+
5
+
1
2
G
N
D
4
0
2
A
U
D
I
OA
U
D
IO
D
I
G
IT
A
L
A
N
A
L
O
G
INTERFACE
POW
ER
D
R
C
S
M
S
L
A
G
L
G
3
9
1
+
5
+
1
2
G
N
D
4
0
2
A
U
D
IO A
U
D
I
O
D
IG
IT
A
L
A
N
A
L
O
G
INTERFACE
P
OWER
D
R
C
S
M
S
L
A
G
L
G
3
9
1
+
5
+
1
2
G
N
D
4
0
2
A
U
D
IO A
U
D
I
O
First Drive
Second Recorder
Super Multi DVD Rewriter
Super Multi DVD Rewriter
Connect the IDE data
cable/DC power cable
to the drive.
❶ Connect the IDE data cable to the back of
the drive.
* Using a 40-pin IDE cable might bring the '04/08/03
error (LOGICAL UNIT COMMUNICATION CRC
ERROR (ULTRA-DMA/32))'.
In this case, substitute to 80-pin type IDE cable is
highly recommended.
This kind of error is hardly detected from some
specific motherboard.
❷ Connect a 4-pin power supply cable from
the computer to the drive.
Replace the cover,
connect the power cord
and restart your computer.
• Your computer configuration may different
from the illustrations.
❶ IDE Cable
Reserved
❷ DC Power
Cable