LG GSA-H50L Instruction manual

Installing the Drive

Before installing the drive, turn off the system power.

Disconnect the power cord, and remove the cover.

•Remove a vacant 5.25” drive bay panel from the computer. Slide the drive into the drive bay.

Set the rear of the drive as necessary.

A. When using a Primary IDE port

If you need to connect your drive to the same primary IDE channel as the hard drive, the drive should be set to SLAVE position.

B. When using a Secondary IDE port

If there is no device connected to the secondary IDE channel, connect the drive to this channel and set the jumper to MASTER.

When two drives are connected, set one drive to MASTER and the other drive to SLAVE. If your operating system encounters interface problems after installing the new drive, try swapping the jumpers or move one drive to another IDE channel.

Method A

Super Multi DVD Rewriter

Super Multi DVD Rewriter

Method B

Super Multi DVD Rewriter

Super Multi DVD Rewriter

Super Multi DVD Rewriter

First Drive

Second Recorder

Connect the IDE data cable/DC power cable to the drive.

Connect the IDE data cable to the back of the drive.

*Using a 40-pin IDE cable might bring the '04/08/03 error (LOGICAL UNIT COMMUNICATION CRC ERROR (ULTRA-DMA/32))'.

In this case, substitute to 80-pin type IDE cable is highly recommended.

This kind of error is hardly detected from some specific motherboard.

Connect a 4-pin power supply cable from the computer to the drive.

Replace the cover, connect the power cord and restart your computer.

•Your computer configuration may different from the illustrations.

	Reserved	DC DCPowerPowerCable
	IDE Cable
		Cable