Installation
Hardware Installation
NOTES
you have a personal computer with USB port before connecting the drive
.
all device should be turn off before the cables.
To AC wall outlet.
converter cable
Connecting to computer
Connect the drive to the computer as shown in figure.
Connect the other end of the USB converter cable to your computer.
Connect the AC adapter plug to the power connector at the rear of the drive. Attach the AC adapter to the AC wall outlet.
When the computer is ready, confirm that the drive is detected. And then, insert the supplied software CD into the External Super Multi DVD Rewriter and install the software.
NOTES
not connect the AC adapter and converter cable by any means other
specified above.
•The machine does not have an ON/OFF switch. As soon as it is connected to the AC power, the power up sequence begins.
The power supply cord is intended to serve as the main disconnect device. The power outlet shall be near the equipment and shall be easily accessible.
•The appliance is not intended for use by young children or infirm persons without supervision.
•Young Children should be supervised to ensure that they do not play with appliance.
•If the appliance is supplied from a cord extension set or an electrical portable outlet device, the cord extension set on electrical portable outlet device must be positioned so that it is not subject to splashing or ingress of moisture.
Location and function of controls
This following is the general figure of the design of the drive.
The drive’s appearance and specifications may change without prior notice.
Front
Tray
activity indicators
used to indicate the operation of
Super Multi DVD Rewriter.
Eject Hole
Button
1 |
2 |
3 |
4 |
Rear
1.USB Connector
This connector is used to connect to the USB converter cable.
2.Power Connector
This connector is used to connect to the AC Power adapter cord.
1 2
the USB converter cable
supports the plug and play(not swap) function of Windows, and can be removed and inserted by the following operation.
application software being currently used.
icon “ ” of the taskbar located on your screen’s bottom right side.
Remove USB Mass Storage Device-Drive[x:]”.
and then remove the USB converter cable.
NOTE
Don’t remove the USB converter cable when the busy indicator on the drive blinks, or during computer startup.