LG GR-P289FTJ Owner’s Manual

P/NO : MFL32049817

Entry

Important safety instructions

Identification of parts

Where to install

Door removal

Door replacement

Water supply installation

Height adjustment

Setup

Adjusting the temperatures and functions

Refreshment center (Applicable to some models only)

Shelf (Applicable to some models only)

Wine holder (Applicable to some models only)

Egg Box (Applicable to some models only)

Humidity control in the vegetable compartment

Deodorizer (Applicable to some models only)

Miracle Zone Temperature Transition Corner (Applicable to some models only)

Temperature Change at Miracle Zone (Applicable to some models only)

Miracle Zone (Applicable to some models only)

Location of foods

Storing foods

How to remove and replace parts

General information

Cleaning

Troubleshooting

Table of Contents

Introduction

Installation

Operation

Suggestion on

food storage

Care and

maintenance

3 3

7 8

Entry

The model and serial numbers are found on the inner case or back of refrigerator compartment of this unit. These numbers are unique to this unit and not available to others. You should record requested information here and retain this guide as a permanent record of your purchase. Staple your receipt here.

Date of purchase Dealer Dealer address Dealer phone Model Serial

Before use, this refrigerator must be properly installed and located in accordance with the installation instructions in this manual.

Never unplug your refrigerator by pulling on the power cord. Always grip the plug firmly and pull it straight out from the outlet.

When moving your appliance away from the wall, be careful not to roll over the power cord or to damage it in any way. Do not crush or damage the water line.

After your refrigerator is in operation, do not touch the cold surfaces in the freezer compartment, particularly when your hands are damp or wet. Skin could adhere to these extremely cold surfaces.

Unplug the power cord from the power outlet for cleaning or other requirements. Never touch it with wet hands because you can get an electric shock or be injured.

Never damage, bend, kink, pull out, or twist the power cord because damage to the power cord can cause product failure, fire, or electric shock. If you have doubts the appliance is properly grounded, consult a qualified electrician.

Never place glass products in the freezer because they may be broken from expansion when their contents are frozen.

Never put your hands within the ice storage bin of the automatic icemaker. You can be injured by the operation of the automatic icemaker.

The appliance is not intended for use by young children without supervision.

Young children should be supervised to ensure that they do not play with the appliance.

Never allow anyone to climb, sit, stand, or hang on the door. These actions may damage the refrigerator and even tip it over, causing severe personal injury.

The refrigerator-freezer should be so positioned that the supply plug is accessible for quick disconnection in the event of an emergency.

If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid any hazard.

Do not modify or extend the Power Cord length.



It may cause electric shock or fire.

Introduction

Important safety instructions

Accessibility of

supply plug

Supply cord

replacement

Warning

DANGER: Risk of child entrapment.

Before you throw away your old refrigerator or freezer take off the doors but leave the shelves in place so that children may not easily climb inside. The appliance is not intended for use by young children without supervision. Young children should be supervised to ensure that they do not play with the appliance.

Don’t store or use gasoline or other flammable vapor and liquids in the vicinity of this or any other appliance.

In the event of an electric short circuit, grounding (earthing) reduces the risk of electric shock by providing an escape wire for the electric current. In order to prevent possible electric shock, this appliance must be grounded. Improper use of the grounding plug can result in an electric shock. Consult a qualified electrician or service person if the grounding instructions are not completely understood, or if you have doubts on whether the appliance is properly grounded.

Child entrapment

warning

Don’t store

Grounding

Introduction

•

Parts, features, and options vary by model. Your model may not include every option.

NOTE

Freezer Compartment

Refrigerator Compartment

Dairy Corner

Water Filter

Lamp

Automatic

Icemaker

Shelf

(steel or glass)

Shelf

(steel or glass)

Door Rack

(Plastic or wire)

Drawer

(Plastic or wire)

Door Rack

Lower Cover

Shelf

Home Bar (Optional)

Snack Drawer

Lamp

Vegetable Drawer

Door Rack

Miracle Zone (Optional) Fresh compartment (Optional)

Identification of parts

Installation

Strong

and even floor

A proper

distance from

adjacent items

Where water

supply can be

easily connected

in a dry place

Where it is free

from heat

To ensure proper air circulation around the fridge -freezer, please maintain sufficient space on both the sides as well as top and maintain at least 2 inches (5 cm) from the rear wall.

Select a place where a water supply can be easily connected between the automatic ice maker and dispenser. Installing the refrigerator in a wet or damp area may cause rust and may be an electrical hazard.

If this refrigerator is installed where the ambient temperature is high, the freezing capacity is deteriorated and the cost of electricity used increases.

Where to install

Unstable installation may cause vibration and noise. If the floor to install the refrigerator on is not even, make the refrigerator level by rotating the height adjusting screw.

•

Install the refrigerator at a place where the ambient temperature is 5˚C ~ 43˚C. Ambient temperature outside this range may cause product malfunction. Also, the tube between the dispenser and automatic ice maker may freeze.

NOTE

Bottom Pad

Height

More than

5 cm

to back

Door removal

Electric Shock Hazard

Disconnect electrical supply to refrigerator before installing. Failure to do so could result in death or serious injury.

If your entrance door is too narrow for the refrigerator to pass through, remove the refrigerator door and pass the refrigerator laterally.

Remove the lower cover by lifting upward, and then pull up the water feed tube while pressing the release ring



shown in the figure to the right.

Remove lower

cover and

water feed tube

Warning

Remove the

freezer

compartment

door

Remove the

refrigerator

door

Installation

1) Remove the hinge cover by loosening the screws. Disconnect all connections except the ground line.

2) Remove the keeper by rotating it counter

clockwise and then lifting the upper hinge up

.

3) Remove the freezer compartment door by lifting it upward. This time, the door should be lifted enough for the water feed tube to be completely pulled out.

1) Loosen the hinge cover screws and remove the cover. Remove connection wire, if any, except for the ground line.

2) Remove keeper by rotating it clockwise () and then remove the upper hinge by lifting it up ().

3) Remove the refrigerator compartment door by lifting it up.

•

If a tube end is deformed or abraded, trim the part away. Disconnecting the tube under the door causes about 2 liters water to flow out. Please put up a big container to prevent it.

NOTE

•

When removing the upper hinge, be careful that the door does not fall forward .

NOTE

•

After removing the door, take it into the kitchen where you are installing the refrigerator. Lay it down on a blanket and be careful to avoid damaging the water feed tube.

NOTE

Lower Cover

Lower hinge

Lower Hinge

Keeper

Water Feed Tube

Connection Wires

Connection

Wires

Hinge Cover

Upper Hinge

Keeper

Upper Hinge

Ground Line

Installation

Door replacement

Water supply installation

Pass the refrigerator laterally through the access door as shown in the right figure.



Automatic icemaker operation needs water pressure of 147~834 kPa (1.5~8.5 kgf/cm2) (That is, an instant paper cup (180 cc) will be fully filled within 3 seconds.)



If water pressure is less than 147 kPa. It is necessary to purchase a separate pressure pump for normal automatic icemaking and cool water feed.



Keep the total length of the feed water pipe tube within 8 m. Be careful for the tube to avoid being kinked. If the tube is longer than 8 m, the pressure may drop to an unacceptable level.



Install the water supply line where it will not be affected by heat.



Connect to potable water supply only.



Refer to instructions with water filter kit for installation.

Mount them in the reverse sequence of removal after they pass through the access door.

Pass the

refrigerator

Before

installation

Warning

This appliance contains fluids (refrigerant and lubricant) and is made of parts and materials which are reusable and/or recyclable. All the important materials should be sent to the collection center of waste material and can be reused after rework (recycling). For recycling, please contact the local agency.

Disposal of the

old appliance

M a x

FRZ TE M P REF TEMP

Min

Max

Installation

Height adjustment

Level them by inserting a flat (

type) driver into the groove of the left height adjusting

screw and rotating it clockwise ().

Level them by inserting a flat (

type) driver into the groove of the right height

adjusting screw and rotating it clockwise ().

The refrigerator door will close smoothly by raising the front side by adjusting the height adjusting screw. If the door does not close properly because it is improperly adjusted, the performance of the refrigerator will be affected.

If the freezer

compartment door

is lower than the

refrigerator

compartment door

If the freezer

compartment door

is higher than the

refrigerator

compartment door

After leveling the

door height



1. Wipe off all dust accumulated during shipping and clean your appliance thoroughly.

2. Install accessories such as the ice cube box, cover evaporating tray, etc., in their

proper places. They are packed together to prevent possible damage during shipping.

3. Connect the power supply cord (or plug) to the outlet. Use this appliance on a

dedicated circuit.

Operation

Setup

Adjusting the temperatures and functions

When your refrigerator is first installed, allow it to stabilize at normal operating temperatures 2~3 hours prior to filling it with fresh or frozen foods. If operation is interrupted, wait 5 minutes before restarting.

(Hidden)

Display Power Saving Mode

Refreshment Center Button

Refreshment Center

•

Your model may not include every option.

•

The control display is operated by touch. Excessive moisture on the display may cause a malfunction. Please keep display clean and dry.

NOTE

+ 20 hidden pages

LG GR-P289FTJ Owner’s Manual

Specifications and Main Features

Frequently Asked Questions

User Manual