LG GR-051SNS Owner’s Manual

2

INSTALLATION

THIS REFRIGERATOR IS MANUFACTURED WITH GREAT CARE, AND UTILIZES THE
LATEST IN TECHNOLOGY.
WE ARE CONFIDENT THAT YOU WILL BE FULLY SATISFIED WITH IT'S PERFORMANCE
AND RELIABILITY.
BEFORE YOU START YOUR REFRIGERATOR, PLEASE READ THIS BOOKLET CAREFULLY.
IT PROVIDES EXACT INSTRUCTIONS FOR INSTALLATION, OPERATION AND
MAINTENANCE, AND ALSO SUPPLIES SOME USEFUL HINTS.

1. Select a good location.
Place your refrigerator where it is easy to use.

2. Avoid placing the unit near heat sources, direct
sunlight or moisture.

3. There must be proper air circulation around
your refrigerator to keep it operating efficiently.
If your refrigerator is placed in a recessed area
in the wall, allow at least a 10 inch or greater
clearance above the refrigerator and 2 inches or
more from the wall.
The refrigerator should be elevated 1 inch from
the floor, especially if it is carpeted.

4. To avoid vibrations, the unit must be level.
If required, adjust the leveling screw to
compensate for unevenness of the floor.
The front should be slightly higher than the rear
to aid in door closing.
Leveling screw can be turned easily by tipping
the cabinet slightly.
Turn the leveling screw clockwise to raise the
unit, counterclockwise to lower it.

5. Clean your refrigerator thoroughly and wipe off
all dust accumulated during shipping.

6. Install accessories such as ice tray, shelf, etc.,
in their proper places.They are packed together
to prevent possible damage during shipment.

7. Connect the power supply cord (or plug) to the
outlet. Don't double up with other appliances on
the same outlet.

8. Prior to use, leave your refrigerator on for 2 or 3
hours.
Check the flow of cold air on the evaporator to
ensure proper cooling.
Your refrigerator is now ready for use.

3828JD8498Q(O/M)¿ ‡ »` 02.9.19 11:30 AM ˘`2

3

FEATURE CHART

Ice Tray

Magnetic Door Seal
Door Rack
Leveling Screw

Thermostat Dial

For controlling the
temperature
in the refrigerator.

Evaporator

Drip Tray & Shelf

Catches the water that drips
off the evaporator when
defrosting, and have full width
and can slide out.

3828JD8498Q(O/M)¿ ‡ »` 02.9.19 11:30 AM ˘`3

STARTING

When your refrigerator is first installed, allow it 2-3 hours to stabilize at normal operating temperature
prior to filling it with fresh food.

If operation is interrupted, allow a 5 minute delay before restarting.

TEMPERATURE CONTROL

ICE MAKING

● To make ice cubes, fill the ice tray with water and place

it on the evaporator.

● To remove ice cubes, hold the tray at its ends and twist

gently.

To remove ice cubes easily, run water on the tray
before twisting.

4

OPERATION

Your refrigerator has a control that let you regulate
the temperature in the refrigerator.

Initially, set the control at mid-position.
For colder temperatures, adjust the control to a

higher number, and for warmer temperatures, adjust
the control to a lower number.

TIP

0

7

6

5

4

3

2

1

3828JD8498Q(O/M)¿ ‡ »` 02.9.19 11:30 AM ˘`4