LG GL-B492GLPL, GR-M613GLHL, GL-M492GLDR Owner’s Manual

ENGLISH FRENCH ARABIC

P/NO : MFL68488901

Express Freeze

Green Ion Door Cooling / Ice Beam Door Cooling(Optional)

Lamp Replacement

Inverter On feature(Optional)

Smart Diagnosis(Optional) Hygiene Fresh(Optional)

WARNING

Keep ventilation openings, in the appliance enclosure or in the built-in-structure, clear of obstruction. Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer. Do not damage the refrigerant circuit. Do not use electrical appliances inside the food storage compartment, unless they are recommended by the manufacturer. The refrigerant and insulation blowing gas used in the appliance requires special disposal procedures. When disposal, please consult with services agent or a similarly qualified person.

If gas used is R600a

This appliance contains a small amount of isobutane refrigerant (R600a), natural gas with high environmental compatibility, but it is also combustible. When transporting and installing the appliance, care should be taken to ensure that no parts of the refrigerating circuit are damaged. Refrigerant squirting out of the pipes could ignite or cause an eye injury. If a leak is detected, avoid any naked flames or potential sources of ignition and air the room in which the appliance is standing for several minutes.

Never startup an appliance showing any signs of damage. If in doubt, consult your dealer.

All electrical and electronic products should be disposed of separately from the municipal waste stream via designated collection facilities appointed by the government or the local authorities.

The correct disposal of your old appliance will help prevent potential negative consensus for the environment and human health.

For more detailed information about the disposal of your old appliances, please contact your city office, waste disposal service or the shop where you purchased the product.

(*NOTE - 1,2,3 are applicable for Jordan Regulations and other countries as per applicability)

Do not use or store inflammable materials like ether, benzene, alcohol, medicine, LP gas, spray or cosmetics near or in the refrigerator.

It may cause explosion or fire.

Install in places away from the fire such as the place where flammable gas is leaked.

It may cause fire.

like gasket

Completely empty inside before taking out the container from the door.

8910

Inverter-On feature (Optional)

Minimum requirement: UPS/ Inverter should be in ON condition having minimum 600VA capacity along with minimum 120Ah capacity battery connected with the refrigerator’s power supply socket.

Green Ion Door Cooling / Ice Beam Door Cooling

(Optional)

(Factory Recommended Location)

GL-*5**/ GL-*6**

GL-*4**

‘3’ or ‘4’.

‘3’ or ‘5’.

When the freezer compartment is not cold enough in winter, adjust the control for the freezer to High (4~7 / 8 / ● / ).● ●

For achieving temperature in Freezing, Energy and Storage Test, Freezer control may be required to set at “●” or “●●”

6 5 4

*Refer Freezer control label inside freezer compartment

CONTROLS FOR REFRIGERATOR COMPARTMENT

Display ‘A’

Display ‘B’

Press ‘FRIDGE’ button to control refrigerator temperature.

Press ‘Hygiene Fresh’ button to operate hygiene fresh motor (optional).

Display ‘A’

Power mode ON

Display ‘B’

- Press (c) button, refrigerator temperature will be down by 1 C.

- Press (d) button, refrigerator temperature will be up by 1 C.

OFF.

EXPRESS FREEZE

When the refrigerator is first turned ON the EXPRESS FREEZE feature can be turn ON. The compressor and circulating fan operate at maximum cooling capacity to quickly lower the refrigerator temperature. It shuts off automatically.

If warm food is placed into the refrigerator, EXPRESS FREEZE can be started with the button on the control panel. EXPRESS FREEZE will shut off when the temperature reaches the proper level or it can be shut off manually by pressing the EXPRESS FREEZE button.

Display ‘A’

Display ‘B’

Display ‘A’

Note: This feature will be unlocked by itself, if the refrigerator is switched off.

GREEN ION DOOR COOLING / ICE BEAM DOOR COOLING (OPTIONAL)

ICE MAKING (OPTIONAL)

Display ‘B’

LAMP REPLACEMENT

NOTE : This product applies LED Lamp which cannot be replaced

by the user. Please contact authorized service centre for the lamp replacement.

INVERTER-ON FEATURE (Optional)

1. While using this feature, the refrigerator will work on basic requirement as required by the product.

2. The results of the Inverter-On feature may vary depending on the number of appliances that are running on inverter.

3. For optimum running of refrigerator during Inverter-On mode, it is recommended to switch off the other appliances which are not in use.

4. It is recommended to confirm the quality of food items before consumption.

5. Ice cream etc. may get soften during the use of this feature, if situation arises so, it is recommended to change the setting as per one’s choice.

(OPTIONAL)

SMART DIAGNOSIS (Only for Selected External Micom Models)

Smart diagnosis function is...

Use this function when calling the Customer Call Centre and receive precise diagnosis when the Refrigerator malfunctions or fails. Use it only when advised by the consultant and not otherwise.

How to use the function

1. Close all refrigerator doors, and press and

hold display lock button to make it locked state.

If the display is already in locked state, press and hold lock button to reset the lock and press and hold the lock button again to make it locked state.

CAUTION

If it passes 5 minutes in locked state, smart diagnosis function will not be activated, so be careful.

3. Open all refrigerator compartment and freezer compartment doors, and place the telephone near the speaker hole at the top right side.

Check if the speaking side(microphone) of the telephone is toward the speaker hole.

4. Do not take away the telephone while data is being transmitted.

During the data transmission for smart diagnosis, wait with the telephone placed near the speaker hole at the top right side. The remaining time for data transmission is displayed on the display screen.

2. Press and hold fridge temperature button

for 3 seconds or longer. (All display screens will be turned off, and in a while, 3 will be displayed on the fridge temperature display part.)

< Model with Hygiene Fresh Filter >

< Model without Hygiene Fresh> Filter >

CAUTION

The transmission sound may be irritating. Do not take away the telephone until the sound stops for good diagnosis.

5. After the completion of the data transmission, listen to the explanation of the consultant about the result of the smart diagnosis.

When the data transmission is completed, along with the display of the data transmission completion, the refrigerator will be automatically turned off and on a few seconds later. Listen to the explanation of the consultant about the result of the analyzed diagnosis and follow the instructions.

Be aware!

Difference of the regional call qualities may have influence on the function. If you use home phone, better communication performance will enable much better service. Smart diagnosis data transmission may not be fluent due to call quality problem, and in such case, smart diagnosis service may be difficult.

SMART DIAGNOSIS (Only for Selected Internal Micom Models)

Smart diagnosis function is...

Use this function when calling the Customer Call Centre and receive precise diagnosis when the Refrigerator malfunctions or fails. Use it only when advised by the consultant and not otherwise.

How to use the function

First, call LG service center. Only use the Smart Diagnosis feature when instructed to do so by the LG call center agent.

1. Open all the doors of the refrigerator.

2. Press the refrigerator control (REF TEMP)

button for 3 sec or more.

3. If the buzzer sounds 4 times (Frequency of

SDS Buzzer is 2000Hz, 0.2sec Off/ 0.2sec On 4 times) place the phone near the speaker hole in the top right hand side door hinge.

5. Do not take away the telephone while data is being transmitted.

CAUTION

The transmission sound may be irritating. Do not take away the telephone until the sound stops for good diagnosis.

6. During the data transmission for smart diagnosis, hold the telephone 10cm away from the speaker hole and avoid any background noises. After inputting SDS, SDS buzzer will ring. After completion of the data transmission, the consultant will explain the result of the smart diagnosis and ad v ice ac cordi ngly. Wh en the dat a transmission is completed, the refrigerator will be automatically turned off and on a few seconds later.

4. Ensure the microphone of the telephone is

towards the speaker hole.

Be aware!

Difference of the regional call qualities may have influence on the function. If you use home phone, better communication performance will enable much better service. Smart diagnosis data transmission may not be successful if the call is made from a mobile phone with poor network reception.

OPERATIONS

HYGIENE FRESH (OPTIONAL)

CAUTION

Before installing or using the product, make sure to read the owner's manual carefully to use the product accurately as intended. This HYGIENE FRESH filter has the antibacterial function of removing the virus or bacteria inside the refrigerator and the deodorizer function to remove the scent.

The function has tested and has been certificated by authorized institutions Intertek

Switch over to use mode

Switch over to use mode.

To use the HYGIENE FRESH filter, press the

•

front side of the door and switch over to the AUTO or POWER mode. (Whenever you press the button, the HYGIENE FRESH filter will be switched to OFF

AUTO

POWER OFF.)

OFF AUTO POWER OFF

button on the display panel on the

CAUTION

When the user switches to AUTO or POWER mode, the LED around the filter is also turned on. Open the door to check whether the LED around the filter is also turned on. Do not put in your finger or alien particles inside the fan. It can be caused of an injury or malfunction.

CAUTION

Do not wash the HYGIENE FRESH filter by using water because It can be caused of malfunction.

•

This filter may not be effective for all types of bacteria and virus.

•

This is effective to remove the bacteria which is not on the food in the refrigerator.

You can purchase the HYGIENE FRESH filter at the nearest distributor or the service center.

LED PATTEN DURING INVERTER-ON MODE (OPTIONAL)

During the use of this feature, you will find this pattern of LED running. It is a symbol that the product is running at basic energy requirement. One can press the button “REF TEMP” to change the LED setting during power cuts, if needed. The LED will then show the setting as desired. When the mode is changed from Normal supply to Inverter mode & vice versa, the LED pattern will take some time to display the change.

2223242526

SUPPLY CORD REPLACEMENT

If the supply cord is damaged, it must be re pl ac ed by th e manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.

Disposal of the old appliance

This appliance contains fluid (refrigerant, lubricant) and is made of parts and materials which are reusable and/or recyclable.

All the important materials should be sent to the collection center of waste material and can be reused after rework (recycling). For take back, please contact with the local agency.

“(For CENELEC countries) This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.”

+ 58 hidden pages