LG GCS175GV, GCS115GV, GCS325GV Owner’s Manual

Please read this manual carefully before operating
your set and retain it for future reference.

P/No.:MFL67107301

www.lg.com

INSTALLATION ..........................................3

CONTENTS

POWER SOURCE AND TEST - RUNNING

FEATURE CHART.......................................4

OPERATIONS..............................................5

ADVICE ON FOOD STORAGE...................5

CARE AND CLEANING...............................6

MAINTENANCE...........................................6

IMPORTANT WARNINGS .......................7-8

TROUBLE SHOOTING................................9

BEFORE CALLING FOR SERVICE ..........10

............3

2

INSTALLATION

1. Place your chest freezer at a convenient location.

2. Avoid placing the near any heat sources, direct
sunlight or moisture.

3. Clean your chest freezer thoroughly and wipe off
all dust accumulated during transportation.

4. Connect the power supply cord to the outlet.
Don't plug other appliances to the same outlet.

5.Before use, remove all the packing material. The
back side of the cabinet should be more than
20cm away from the wall, both flank sides more
than 20cm.

6.The chest freezer should be put in well-ventilated,
dry place. Don’t use it under direct sunshine. The
chest freezer should be kept away from water sink,
heat source and any volatile,corrosive material.

POWER SOURCE AND TEST RUNNING

1.Specified capacity of the wire is 6A. Section squares of the wire is 0.75mm. Single line or compound lines
are all allowed.The fuse of 2.5A specified electric current should be installed. (Power cord should be
replaced with the same of 6A and 0.75mm,when it is damaged).

2.Single-phase power supply,50Hz,voltage range187~242V.If the voltage is unstable, please install a voltage
stabilizer with capacity above1000W.

3.Avoid turning on and off the power too frequently. If the power is turned off,wait an interval of 5 minutes
before turning it on again.

4.When the chest freezer will be out of use for along time,disconnect the power first,then clean it. Please
examine the circuit whether it is excellent before reuse.

3