WASHING
MACHINE
Please read this manual carefully before operating
your washing machine and retain it for future reference.
FH8B8NDL22 FH0B8NDL25 FH096WDL24
FH0B8NDL22 FH0B8WDL2 FH296HDL23
FH0B8NDL2 FH0B8WDL24 FH296HDL24
FH0B8NDL21 FH096WDL23
MFL67584554
P/NO : MFL67584554
Rev. No.: 00
Drawer
(For detergent and fabric softener)
Door
Lower cover
Adjustable leg
Power Plug
If the supply cord is damaged, it must be replaced by the
manufacturer or its service agents or a similarly quali ed person in order to avoid a hazard.
Control Panel
Drum
Drain Pump Filter
Drain Plug
Lower Cover Cap
6.0kg : [FH0B8NDL2 / FH0B8NDL25 / FH0B8NDL22 / FH0B8NDL21]
[FH8B8NDL22]
6.5kg : [FH0B8WDL2 / FH0B8WDL24 / FH096WDL23 / FH096WDL24]
7.0kg : [FH296HDL23 / FH296HDL24]
No Spin/400/600/800 [FH8B8NDL22]
No Spin/400/800/1000 [FH0B8NDL2 / FH0B8WDL2]
[FH0B8NDL25 / FH096WDL23]
[FH096WDL24 / FH0B8NDL22/ FH0B8NDL21 / FH0B8WDL24] No Spin/400/800/1200 [FH296HDL24 / FH296HDL23]
carpeted floor.
subjected
in
caused
Unpacking
Cut the straps and open the upper aps of Packing box & take out the Anti Rat Cover. While taking out the Machine from packing, please take due care in removing packing support given at centre of the base packing.
Anti Rat Cover is placed below the upper
aps of the Packing box.
Packing Support
Anti Rat Cover installation
Accessories for xing Anti Rat Cover.
1.Take out the poly bag (containing Screws/Washers).
2.Tilt the machine sideways.
3.Bend & insert the aps of Anti Rat Cover into the bottom side of machine.
4.Assemble the Anti Rat Cover on the bottom side of the machine by using Screws & Washers.
Machine.
5
adjustable legs
It is advisable to avoid, the usage of trolley & the movement of Washing Machine after installation. As it may disturb the levelling of washer, which can create excessive noise & vibration.
6
(0.3~10kgf/cm²)
Part can be different according to different models.
Two rubber seals are provided with inlet hose connectors.
These are used to prevent water leakage.
Make sure the connection to tap is suf ciently tight.
Check rubber seals in inlet hose |
Screw the hose connector onto |
connectors. |
water supply tap. |
Hose
Connector
Rubber seal