WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK
HAZARD, DO NOT EXPOSE THIS PRODUCT TO RAIN
OR MOISTURE.
WARNING: Do not install this equipment in a
conned space such as a book case or similar unit.
CAUTION: Do not block any ventilation openings.
Install in accordance with the manufacturer’s
instructions.
Slots and openings in the cabinet are provided for
ventilation and to ensure reliable operation of the
product and to protect it from over heating. The
openings shall be never be blocked by placing
the product on a bed, sofa, rug or other similar
surface. This product shall not be placed in a builtin installation such as a bookcase or rack unless
proper ventilation is provided or the manufacturer’s
instruction has been adhered to.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
This lightning ash with arrowhead
symbol within an equilateral
triangle is intended to alert the
user to the presence of uninsulated
dangerous voltage within the
product’s enclosure that may be of
sucient magnitude to constitute a
risk of electric shock to persons.
The exclamation point within
an equilateral triangle is
intended to alert the user to the
presence of important operating
and maintenance (servicing)
instructions in the literature
accompanying the product.
CAUTION: This product employs a Laser System.
To ensure proper use of this product, please read
this owner’s manual carefully and retain it for future
reference. Shall the unit require maintenance,
contact an authorized service centre.
Use of controls, adjustments or the performance of
procedures other than those specied herein may
result in hazardous radiation exposure.
To prevent direct exposure to laser beam, do not
try to open the enclosure.
CAUTION concerning the Power Cord
Most appliances recommend they be placed upon
a dedicated circuit;
That is, a single outlet circuit which powers only
that appliance and has no additional outlets or
branch circuits. Check the specication page of this
owner’s manual to be certain. Do not overload wall
outlets. Overloaded wall outlets, loose or damaged
wall outlets, extension cords, frayed power cords, or
damaged or cracked wire insulation are dangerous.
Any of these conditions could result in electric
shock or re. Periodically examine the cord of your
appliance, and if its appearance indicates damage
or deterioration, unplug it, discontinue use of the
appliance, and have the cord replaced with an
exact replacement part by an authorized service
centre. Protect the power cord from physical or
mechanical abuse, such as being twisted, kinked,
pinched, closed in a door, or walked upon. Pay
particular attention to plugs, wall outlets, and
the point where the cord exits the appliance. To
disconnect power from the mains, pull out the
mains cord plug. When installing the product,
ensure that the plug is easily accessible.
This device is equipped with a portable battery or
accumulator.
Safety way to remove the battery or the
battery from the equipment: Remove the
old battery or battery pack, follow the steps
in reverse order than the assembly. To prevent
contamination of the environment and bring on
possible threat to human and animal health, the
old battery or the battery put it in the appropriate
container at designated collection points. Do
not dispose of batteries or battery together with
other waste. It is recommended that you use
local, free reimbursement systems batteries and
accumulators. The battery shall not be exposed to
excessive heat such as sunshine, re or the like.
CAUTION: The apparatus shall not be exposed to
water (dripping or splashing) and no objects lled
with liquids, such as vases, shall be placed on the
apparatus.
Getting Started3
yThe appliance is not intended for use by young
children or inrm persons without supervision.
yYoung Children should be supervised to
ensure that they do not play with appliance.
yIf the appliance is supplied from a cord
extension set or an electrical portable outlet
device, the cord extension set on electrical
portable outlet device must be positioned so
that it is not subject to splashing or ingress of
moisture.
2 Safety Information
6 Unique Features
6 Accessories
6 Playable file Requirement
6 – MP3/WMA music file requirement
7 – Compatible USB Devices
7 – USB device requirement
8 Remote Control
9 Front Panel
10 Back Panel (Case1)
10 Back Panel (Case2)
2 Connecting
11 Connecting the speakers to the unit
11 – Case1 : Connecting the speakers to
the unit
11 – Case2 : Attaching the speakers to the
unit
11 Antenna Connection
12 Optional Equipment Connection
12 – USB Connection
12 – PORT. IN Connection
3 Operating
13 Basic Operations
13 – CD/ USB Operations
13 – Selecting a folder
14 Other Operations
14 – Programmed Playback
14 – Displaying file information (ID3 TAG)
14 – Turn off the sound temporarily
15 Radio Operations
15 – Listening to the radio
15 – Improving poor FM reception
15 – Presetting the Radio Stations
15 – Deleting all the saved stations
16 Sound adjustment
16 – Setting the surround mode
16 Listening to music from your external
to [Mastered] in order to make the discs
compatible with the LG players when formatting
rewritable discs. When setting the option to Live
File System, you cannot use it on LG players.
(Mastered/Live File System : Disc format system
for Windows Vista)
-Searches for a folder of MP3/
WMA les. When a CD/ USB
containing MP3/ WMA les in
several folders is being played,
press PRESET/FOLDER W/S
to select the folder you want to
play.
-Choose a preset number for a
radio station.
FUNCTION : Selects the function
and input source.
MUTE : Mutes the sound.
@
VOLUME W/S : Adjusts speaker
volume.
• • • • • • c • • • • • •
INFO : Sees informations about
your music. MP3 les often come
with ID3 tags. The tag gives
the Title, Artist, Album or Time
information.
PROGRAM/MEMO :
-Stores radio stations.
-Creates a playlist you want to
listen to.
REPEAT(MENU) :
Listens to your tracks/les
repeatedly or randomly.
Cc/vV
-Skips Fast backward or Forward.
-Searches for a section within a
track/le.
TUN. -/+ : Selects the radio
station.
ENTER : Stops playback.
Z
(Play/Pause) : Starts or
d/M
pauses playback.
: The button is not available for
?
any function.
(Skip/Search) :
Remove the battery cover on the
rear of the Remote Control, and
insert one (size AAA) battery with
Connect the speaker cable plugs to the SPEAKER
connector.
Connect the red cable plug to the R connector and
the the white one to the L connector.
Connecting11
Caution
>
The speakers contain magnet parts, so colour
irregularity may occur on the TV screen or PC
monitor screen. Please use the speakers far
away from either TV screen or PC monitor.
Antenna Connection
Be sure to fully extend the FM wire antenna.
2
Connecting
colourSpeaker
Red Front
WhiteFront
Case2 : Attaching the
speakers to the unit
To connect the cable to the unit, press each plastic
nger pad to open the connection terminals on the
unit. Insert the wire and release the nger pad.
Connect the black stripe of each wire to the
terminals marked - (minus) and the other end to
the terminals marked + (plus).
The program function enables you to store your
favourite les from any disc or USB device.
A program can contain 20 tracks/les.
1. Insert a CD or a USB and wait for it to be
ordered.
2. Press PROGRAM/MEMO on the remote control
in stop status.
3. Press
Cc/vV
4. Press PROGRAM/MEMO again to save.
3
5. Repeat steps 3-4 to select a next track/file.
Operating
6. Press d/M to play the programmed music
tracks/files.
7. To clear your selection, press Z on the remote
twice.
Note
,
The programs are also cleared when the disc
or USB device is removed, the unit is powered
o or the function is switched to others.
to select a track/file.
Displaying file information
(ID3 TAG)
While playing an MP3 le containing le
information, you can display the information by
pressing INFO.
Turn off the sound temporarily
Press @MUTE on the remote control to mute
your sound.
You can mute your sound, for example, to answer
the telephone, the mute symbol “ ” is displayed in
the display window.
To cancel it, press @MUTE again or change the
volume level.
1. Press FUNCTION on the remote control or
FUNC. on the unit until FM appears in the
display window.
The last received station is tuned in.
2. Auto tuning : Press TUN.-/+ on the remote
control or TUNING -/+ on the unit for about 2
seconds until the frequency indication starts
changing, then release. scanning stops when
the unit tunes in a station.
Manual tuning: Press TUN.-/+ on the remote
control or TUNING -/+ on the unit repeatedly.
3. Adjust the volume by using VOLUME W/S on
the remote control or rotate Volume knob on
the unit.
Improving poor FM reception
Press d/M on the remote control. This will change
the tuner from stereo to mono. Then the reception
will be better than before.
Presetting the Radio Stations
You can preset 50 stations for FM.
Before tuning, make sure to turn down the volume.
1. Press FUNCTION on the remote control or FUNC. on the unit until FM appears in the
display window.
2. Select the desired frequency by pressing
TUN.-/+ on the remote control or TUNING -/+
on the unit.
3. Press PROGRAM/MEMO. A preset number will
blink in the display window.
4. Press PRESET/FOLDER W/S to select the
preset number you want.
5. Press PROGRAM/MEMO. The station is stored.
6. Repeat steps 2 to 5 to store other stations.
7. To listen a preset station, press
PRESET/FOLDERW/S.
Deleting all the saved stations
1. Press and hold PROGRAM/MEMO for two
seconds. “ERASE” will blink in the display
window.
2. Press PROGRAM/MEMO to erase all saved radio
stations.
This system has a number of pre-set surround
sound elds. You can select a desired sound mode
by using EQ.
The displayed items for the Equalizer may be
dierent depending on sound sources and eects.
On DisplayDescription
Sets the sound equalizer on the
mode that is the most similar to
the genre which is included in
the MP3 ID3 tag of song les.
This program lends an
enthusiastic atmosphere to the
sound, giving you the feeling
you are at an actual pop,classic,
jazz or rock concert.
You can enjoy the sound
without equalizer eect.
Reinforces the treble, bass and
surround sound eect.
Note
3
Operating
AUTO EQ
POP
CLASSIC
JAZZ
ROCK
BYPASS
BASS BLAST
(BASS)
,
Maybe you need to reset the surround mode,
after switching the input, sometimes even
after the sound track changed.
Listening to music
from your external
device
The unit can be used to play the music from many
types of external device. (Refer to the page 12)
1. Connect the external device to the PORT. IN
connector of the unit.
2. Turn the power on by pressing 1/!.
3. Select the PORTABLE function by pressing
FUNC. on the unit.
4. Turn the external device and start playing
music.
Auto Power Down
This unit will be power itself o to save electronic
consumption in the case main unit is not
connected to external device and is not used for 25
minutes. So does this unit after 6 hours since Main
unit has been connected to other device using
analogue input.
Please save the original shipping carton and
packing materials. If you need to ship the unit, for
maximum protection, re-pack the unit as it was
originally packed at the factory.
Keeping the exterior surfaces clean
Do not use volatile liquids such as insecticide spray
near the unit.
Wiping with strong pressure may damage the
surface.
Do not leave rubber or plastic products in contact
with the unit for a long period of time.
Cleaning the unit
To clean the player, use a soft, dry cloth. If the
surfaces are extremely dirty, use a soft cloth lightly
moistened with a mild detergent solution. Do not
5
use strong solvents such as alcohol, benzine, or
Appendix
thinner, as these might damage the surface of the
unit.
Notes on Discs
Handling Discs
Never stick paper or tape on the disc.
Storing Discs
After playing, store the disc in its case. Do not
expose the disc to direct sunlight or sources of heat
and never leave it in a parked car exposed to direct
sunlight.
Cleaning Discs
Do not use strong solvents such as alcohol,
benzine, thinner, commercially available cleaners,
or anti-static spray intended for old vinyl records.
Maintaining the Unit
The unit is a high-tech, precision device. If the
optical pick-up lens and disc drive parts are dirty
or worn, the picture quality could be diminished.
For details, please contact your nearest authorized
service centre.