Accessories
AP-WX50
10-Bolts for tilt wall mounting bracket |
10-Wall Anchor Bolt Sleeves |
|
|
|
|
|
|
|
|
|
|
4-Product Bracket Bolts |
4-Product Bracket Bolts(M8X35) |
4-Product Bracket Bolts
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
4-Guide Spacer |
2-Safety locking Bolts |
7-Bolts for tilt wall mounting bracket
Hole Drilling Template
Installation and Setup Guide
Guide Sticker
Tilt wall mounting bracket
Installation and Setup Guide
P/NO : 3828VA0495C
Safety Instructions
- Qualified service technician should install the product properly after reading this manual thoroughly. |
-Qualified service technician should hand this manual over to the customer after installation and ask him/her to read and keep it.
Do not install this product by yourself. Contact the service technician qualified by
the manufacturer.
It may cause injuries.
Contact the qualified service technician for moving or replacing this
product after installing.
Installing the product needs specified technic, so it may cause safety problem to move or install it by yourself.
WARNING
Do not install this product on the place where it cannot be supported.
It may cause the product to fall and could cause injuries.
Do not hang on or impact on this product.
It may cause the product to fall and could cause injuries.
Install this product followed by the instruction of the manual.
Otherwise it may cause serious injuries or damage of the product.
Before installing, check whether the material of wall satisfies the specifications and make sure to use enclosed anchors supplied with the product.
Otherwise it may cause safety problem.
Do not place a heat source (radiator or heater) or a humidifier under the installed product.
It may cause a fire or could give an electric shock.
Make sure to unplug before installing this product.
Otherwise it may cause a fire or could give an electric shock.
NOTES
Do not install this product by yourself. Get some help from others.
It may cause the product to fall and could cause injuries.
When drilling use drill and drill bit specified by the manufacturer. And the depth of the hole should satisfy the specifications.
Otherwise it may cause safety problem.
Do not install this product near a sprinkler, a sensor, a high voltage electric line, any power source or the place where impact or vibration can affect.
Do not install this product barehanded.
It may cause injuries.
<![endif]>KOREAN / ENGLISH
Installation
1 Bracket
Product Bracket
upper
lower
Push the product brackets in the direction shown by arrow 1, then detach the product brackets from the wall mounting bracket.