LG 795FT, FB795CQ DISASSEMBLY
DISASSEMBLY
- 11 -
(a)
(a)
3. TOP SHIELD REMOVAL
1) Remove four screws (a).
2) Remove four screws (b).
3) Remove two screws (c).
4) Remove three screws (d).
2. BACK COVER REMOVAL
1) Remove four screws (a) from the Back
Cover.
2) Slide the Back Cover away from the Front
Cabinet of the monitor.
(a)
(b)
(b)
(b)
(b)
(d)
(d)
(c)
(c)
(a)
(a)
(a)
(a)
1. TILT/SWIVEL REMOVAL
1) Set the monitor face downward.
2) Pressing the latch (a), carefully remove
the Tilt/Swivel by pulling it upward.
- 12 -
6. BOTTOM BRACKET REMOVAL
1) Remove five screws (a).
2) Remove the Bottom Bracket.
(a)
(a)
(a)
(a)
Purity Coil
Tilt Coil
Anode Cap
P403
P402
P401
P202
P201
P701
P906
P901
P304
L701
P902
CDT Earth
Degaussing
Coil
DY-Pin
P301
P302
P308
(a)
(a)
(a)
(a)
4. TOTAL CHASSIS ASSEMBLY REMOVAL
1) Disconnect P901 (Degaussing pin),
P701 (DY pin), P202 (Tilt pin), and
P201 (Purity pin) from the Main PCB.
2) Disconnect P306 (GND Wire),
P304 from the Video PCB.
3) Carefully separate the CDT Board
Assembly from the CDT neck.
4) Discharge the remaining static
electricity by shorting between
the Anode Cap and the CDT ground.
5) Disconnect the Anode Cap
from the CDT.
6) Remove four screws (a).
7) Remove the Total Chassis Assembly
from the Main Frame.
Bottom Bracket
Loading...