LG 47LN549E, 37LP360H User Manual
OWNER’S MANUAL
LED TV
* LG LED TV applies LCD screen with LED backlights.
Please read this manual carefully before operating your set and retain it for future reference.
LN54**
LP36**
LP63**
www.lg.com
ENGLISH
2TABLE OF CONTENTS
TABLE OF CONTENTS
2TABLE OF CONTENTS
3LICENSES
3OPEN SOURCE SOFTWARE NOTICE
4INSTALLATION PROCEDURE
4ASSEMBLING AND PREPARING
4Unpacking
7 Separate purchase
8Parts and buttons
9 Lifting and moving the TV
10 Setting up the TV
10- Attaching the stand
11- Mounting on a table
13- Mounting on a wall
14- Tidying cables
15- How to use Dual Lock™
16 MAKING CONNECTIONS
16 Antenna connection
16Satellite dish Connection
17HDMI connection
17DVI to HDMI connection
18RGB-PC connection
18Component connection
19Speaker output setup
20USB connection
20CI module connection
20Euro Scart connection
21Audio connection
21- Digital optical audio connection
21Headphone connection
22Network setup
22 - Wired network connection
22 - Wireless network connection
23 REMOTE CONTROL
26 MAINTENANCE
26 Cleaning your TV
26- Screen, frame, cabinet and stand
26 - Power cord
26TROUBLESHOOTING
27CAUTION FOR USING EZSIGN 2.0
28SPECIFICATIONS
31IR CODES
32EXTERNAL CONTROL DEVICE SETUP
32RS-232C setup
32Type of connector; D-Sub 9-Pin Male
32RS-232C configurations
33Communication parameters
33Command reference list
34Transmission / Receiving Protocol
WARNING
yyIf you ignore the warning message, you may be seriously injured or there is a possibility of accident or death.
CAUTION
yyIf you ignore the caution message, you may be slightly injured or the product may be damaged.
NOTE
yyThe note helps you understand and use the product safely. Please read the note carefully before using the product.
22 LED Clock connection
LICENSES / OPEN SOURCE SOFTWARE NOTICE 3
LICENSES
Supported licenses may differ by model. For more information about licenses, visit www.lg.com.
Manufactured under license from Dolby Laboratories. “Dolby” and the double-D symbol are trademarks of Dolby Laboratories.
The terms HDMI and HDMI High-Definition Multimedia Interface, and the HDMI logo are trademarks or registered trademarks of HDMI Licensing LLC in the United States and other countries.
ABOUT DIVX VIDEO: DivX® is a digital video format created by DivX, LLC, a subsidiary of Rovi Corporation. This is an official DivX Certified® device that plays DivX video. Visit divx.com for more information and software tools to convert your files into DivX video.
ABOUT DIVX VIDEO-ON-DEMAND: This DivX Certified® device must be registered in order to play purchased DivX Video-on-Demand (VOD) movies. To obtain your registration code, locate the DivX VOD section in your device setup menu. Go to vod. divx.com for more information on how to complete your registration.
“DivX Certified® to play DivX® video up to HD 1080p, including premium content.”
“DivX®, DivX Certified® and associated logos are trademarks of Rovi Corporation or its subsidiaries and are used under license.”
Covered by one or more of the following U.S. patents : 7,295,673; 7,460,668; 7,515,710; 7,519,274
ENGLISH
OPEN SOURCE SOFTWARE NOTICE
To obtain the source code under GPL, LGPL, MPL and other open source licenses, that is contained in this product, please visit http://opensource.lge.com.
In addition to the source code, all referred license terms, warranty disclaimers and copyright notices are available for download.
LG Electronics will also provide open source code to you on CD-ROM for a charge covering the cost of performing such distribution (such as the cost of media, shipping and handling) upon email request to opensource@lge.com. This offer is valid for three (3) years from the date on which you purchased the product.
ENGLISH
4INSTALLATION PROCEDURE / ASSEMBLING AND PREPARING
NOTE
yyImage shown may differ from your TV.
yyYour TV’s OSD (On Screen Display) may differ slightly from that shown in this manual.
yyThe available menus and options may differ from the input source or product model that you are using.
yyNew features may be added to this TV in the future.
yyThe TV can be placed in standby mode in order to reduce the power consumption. And the TV should be turned off if it will not be watched for some time, as this will reduce energy consumption.
yyThe energy consumed during use can be significantly reduced if the level of brightness of the picture is reduced, and this will reduce the overall running cost.
INSTALLATION PROCEDURE
1Open the package and make sure all the accessories are included.
2Attach the stand to the TV set.
3Connect an external device to the TV set.
ASSEMBLING AND PREPARING
Unpacking
Check your product box for the following items. If there are any missing accessories, contact the local dealer where you purchased your product. The illustrations in this manual may differ from the actual product and item.
CAUTION
yyDo not use any unapproved items to ensure the safety and product life span.
yyAny damages or injuries by using unapproved items are not covered by the manufacturer’s warranty. yySome models have a thin film attached on to the screen and this must not be removed.
NOTE
yyThe items supplied with your product may vary depending on the model.
yyProduct specifications or contents of this manual may be changed without prior notice due to upgrade of product functions.
yyFor an optimal connection, HDMI cables and USB devices should have bezels less than 10 mm thick and 18 mm width. Use an extension cable that supports USB 2.0 if the USB cable or USB memory stick does not fit into your TV’s USB port.
|
|
*A = 10 mm |
|
|
< |
A |
A |
*B = 18 mm |
|
|
< |
ASSEMBLING AND PREPARING 5
ENGLISH
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Owner’s manual |
Remote control, |
|
Stand body |
||||
|
|
batteries (AAA) |
|
(See p.10) |
|||
|
|
(See p.23, 24, 25) |
|
|
|||
|
|
|
|
|
|
|
|
Stand base |
|
Stand screws |
|
Desk-mount screw |
(See p.10) |
|
7 EA, M4 x 14 |
|
(See p.11) |
|
|
(See p.10) |
|
|
|
|
|
|
|
Cable holder |
|
Power cord |
|
Protective bracket/bolt |
(Depending on model) |
|
(Depending on model) |
|
(See p.14) |
(See p.14) |
|
|
|
|
|
|
|
|
|
|
|
|
|
or |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Isolator |
|
Dual Lock™ |
EzSign 2.0 Editor CD |
|||||||
(Depending on model) |
|
(Only 32/37/42LP63**) |
(Only 32/37/42/47LN549E) |
|||||||
(See p.6) |
|
(See p.15) |
|
|||||||
ENGLISH
6ASSEMBLING AND PREPARING
NOTE
yyAntenna Isolator Installation Guide
-- Use this to install TV in a place where there is a voltage difference between TV Set and GND of antenna signal.
»» If there is a voltage difference between TV Set and GND of antenna signal, the antenna contact might be heated and excessive heat might cause an accident.
-- You can improve the safety when watching TV by efficiently removing power voltage from TV antenna. It is recommended to mount the isolator to the wall. If it cannot be mounted to the wall, mount it on the TV. Avoid disconnecting the antenna Isolator after installation.
-- Before starting, be sure that the TV antenna is connected.
Wall
ANTENNA/
or
Cable / Antenna
Isolator
Connect to TV.
Connect to Set-Top box.
Connect one end of the isolator to cable/antenna jack and the other to TV set or set-top box.
“Equipment connected to the protective earthing of the building installation through the mains connection or through other equipment with a connection to protective earthing - and to a cable distribution system using coaxial cable, may in some circumstances create a fire hazard. Connection to a cable distribution system has therefore to be provided through a device providing electrical isolation below a certain frequency range (galvanic isolator, see EN 60728-11)”
When applying the RF Isolator, a slight loss of signal sensitivity can occur.
ASSEMBLING AND PREPARING 7
Separate purchase
Separate purchase items can be changed or modified for quality improvement without any notification. Contact your dealer to buy these items.
These devices only work with certain models.
ENGLISH
LG Audio Device |
|
Wireless Dongle |
LED Clock |
|
||
|
|
|
AN-WF100 |
LEC-001 |
|
|
|
Compatibility |
|
32/37/42/47LN548C |
|
|
|
|
|
|
|
|
||
|
|
32/37/42/47LN549C |
32/37/42/47LN549E |
|
32/37/42LP63** |
|
|
|
|
32/37/42LP36** |
|
|
|
|
LG Audio Device |
|
• |
• |
|
• |
|
|
|
|
|
|
|
|
Wireless Dongle |
|
|
• |
|
|
|
AN-WF100 |
|
|
|
|
|
|
|
|
|
|
|
|
|
LED Clock |
|
|
|
|
• |
|
LEC-001 |
|
|
|
|
|
|
|
|
|
|
|
|
The model name or design may be changed depending on the upgrade of product functions, manufacturer’s circumstances or policies.
ENGLISH
8ASSEMBLING AND PREPARING
Parts and buttons
Screen
|
OK |
|
SETTINGS |
Power indicator and |
INPUT |
Remote control sensor |
Buttons |
|
|
|
Speakers |
Button |
Description |
|
Scrolls through the saved programmes. |
|
Adjusts the volume level. |
OK |
Selects the highlighted menu option or confirms an input. |
SETTINGS |
Accesses the main menu, or saves your input and exits the menus. |
INPUT |
Changes the input source. |
/ I |
Turns the power on or off. |
ASSEMBLING AND PREPARING 9
Lifting and moving the TV
When moving or lifting the TV, read the following to prevent the TV from being scratched or damaged and for safe transportation regardless of its type and size.
CAUTION
yyAvoid touching the screen at all times, as this may result in damage to the screen.
yy It is recommended to move the TV in the box or packing material that the TV originally came in.
yy Before moving or lifting the TV, disconnect the power cord and all cables.
yy When holding the TV, the screen should face away from you to avoid damage.
yy Hold the top and bottom of the TV frame firmly. Make sure not to hold the transparent part, speaker, or speaker grill area.
yy When transporting a large TV, there should be at least 2 people.
yy When transporting the TV by hand, hold the TV as shown in the following illustration.
yy When transporting the TV, do not expose the TV to jolts or excessive vibration.
yy When transporting the TV, keep the TV upright, never turn the TV on its side or tilt towards the left or right.
yy Do not apply excessive pressure to cause flexing/bending of frame chassis as it may damage screen.
ENGLISH
ENGLISH
10 ASSEMBLING AND PREPARING
Setting up the TV
Image shown may differ from your TV.
Attaching the stand
|
3 EA |
1 |
M4 x 14 |
Stand Body
Front
Stand Base
2
CAUTION
yyWhen attaching the stand to the TV set, place the screen facing down on a cushioned table or flat surface to protect the screen from scratches.
3
4 EA
M4 x 14
CAUTION
yyMake sure that the screws are inserted correctly and fastened securely. If they are not fastened securely enough, the TV may tilt forward after being installed.
yyDo not use too much force and over tighten the screws; otherwise screw may be damaged and not tighten correctly.
NOTE
yyRemove the stand before installing the TV on a wall mount by performing the stand attachment in reverse.
|
|
ASSEMBLING AND PREPARING 11 |
|||
Mounting on a table |
|
|
|||
|
Securing the TV to a table |
|
|||
1 Lift and tilt the TV into its upright position on a |
Fix the TV to a table to prevent from tilting forward, |
||||
damage, and potential injury. |
|||||
table. |
|||||
Mount the TV on a table, and then insert and |
|||||
- Leave a 10 cm (minimum) space from the |
|||||
tighten the supplied screw on the rear of the stand. |
|||||
|
|||||
|
10 cm |
10 cm |
cm |
10 |
|
|
10 cm |
2
CAUTION
yyDo not place the TV near or on sources of heat, as this may result in fire or other damage.
Attaching the TV to a table
Image shown may differ from your TV.
The TV must be attached to desk so it cannot be pulled in a forward/backward direction, potentially causing injury or damaging the product.
(Only 37/42/47LN54**, 37/42LP36**, 37/42LP63**)
WARNING
yyTo prevent TV from falling over, the TV should be securely attached to the floor/ wall per installation instructions. Tipping, shaking, or rocking the TV may cause injury.
4-Screws
(not provided as parts of the product) Stand
Table
Screws: M4 x L (*L: Table depth + 8-10 mm) ex) Table depth: 15mm, Screw: M4 x 20
ENGLISH
ENGLISH
12 ASSEMBLING AND PREPARING
Adjusting the angle of the TV to suit view
32LN54**, 32LP36**, 32LP63**
Swivel 15 degrees to the left or right and adjust the angle of the TV to suit your view.
15˚ |
15˚ |
Using the Kensington security system
(This feature is not available for all models.)
The Kensington security system connector is located at the rear of the TV. For more information of installation and using, refer to the manual provided with the Kensington security system or visit http://www.kensington.com.
Connect the Kensington security system cable between the TV and a table.
37/42/47LN54**, 37/42LP36**, 37/42LP63**
Swivel 90 degrees to the left or right and adjust the angle of the TV to suit your view.
90˚ |
90˚ |
CAUTION
yyWhen adjusting the angle of the product, watch out for your fingers.
»» Personal injury may occur if hands or fingers are pinched. If the product is tilted too much, it may fall, causing damage or injury.
Loading...