Quick Installation Guide
ESP-2400
24-Port PoE Surge Protector, 6KV, 30W
A PoE surge protector is an appliance or device designed to protect electrical devices
from voltage spikes as PoE (Power over Ethernet) is in use as typical application
below.
Specifications
Model
ESP-2400
Features
24-Port PoE Surge Protector, 6KV, 30W
Standards Compliance
IEC61000-4-5
Bandwidth
Up to 68MHz
Maximum Input
58VDC
Insertion Loss
<0.2dB
Return Loss
16dB @ 100Ω
Frequency Response
Up to 3dB@68MHz
Insulation Resistance
10,000 MΩ
Peak Discharging Current
150A for 10/700us
Maximum Surge Voltage
Up to 6KV
Surge Life
30000 operations @ 4kV
Surge Protection
<1ns
Common Mode
6KV for 10/700us
Differential Mode
2KV for 10/700us
PoE Passing Capability
30W
Ethernet Connector- In
RJ45
Signal Passing Capability
Breakdown voltage- 58V
Clamping voltage- 77V
Ethernet Connector- Out
RJ45
Internal Impedance
40 Ω Nominal
PoE Support
IEEE802.3af /at
PoE Mode
End-Span (Pin 1,2,3,6)
Material
Metal
Operating Temperature
-40~185 F (-40~85C)
Operating Humidty
20-95% Non-condensing
Dimensions
54*13*9.5cm
Weight
1.5kgs
Packing Content:
1. Rack PoE Surge Protector
2. Grounding wire
3. QIG
Installation Procedure:
1. Connect RJ45 cable from PoE Switch port to PoE IN #8 on the Surge Protector and
other RJ45 cable from PoE OUT #8 to remote PoE PD (Powered Device) such as IP
camera, IP WiFi Access Point, etc. The overall Ethernet connection distance is not
longer than 100 meters. Suggest to add single surge protector prior to PoE PD
device if it does not embed with surge protection circuitry.
2. The LED will be lit in green if IEEE 802.3at/af PoE (PSE injecting power via end-
point pin 1,2,3,6) is in use only. (It is not lit if no PoE is enabled and functioned.)
3. Connect the grounding wire with the rack cabinet for grounding.
Loading...