Let's Go Aero ACC 3103 User Manual
LGT Top Load Base Rack
Part No. ACC 3103
User Assembly Manual
The Top Load Base Rack is an optional accessory for the use of carrying kayaks and other equiptment on the LittleGiant
Trailer.
Top Load Base Rack shown with Racks in Inside Conguration Top Load Base Rack shown with Racks in Outside Conguration
Parts List
Description Qty
Overhead Bars 72” 2
Uprght Bars 4
Base Plates 4
Pin Nuts 4
2.5 X 5/16 Fine Thread
Nuts and Bolts
2 X 5/16 Coarse Thread
Nuts and Bolts
3/8 x 1-3/4 Bolt 4
4
12
Base Plates
Pin Nuts
Tools Needed
11/32 Drill Bit
Drill
1/2” Socket
1/2” Wrench
Uprights
Copyright © 2012 Let’s Go Aero, Inc.
Overhead Bars 72”
ACC3103rev0614
Top Load Base Rack Assembly
Assembly
Step 1: Attach Base Plate with Endgate Bracket to Trailer
Remove the body side latch using a 1/2” tool.
The overhead base plates are notched to t over the end gate latch and the notch must face downward and t over the
end gate side latch.
Position the base plate over the end gate latch and secure with the existing latch hardware and shown in image. Place
HexCap latch plates (if using HexCap accessory) on the outside of the base plate as shown in image.
Level the Base Plate, mark the top hole on the Base Plate and drill though the U-Tube and Side Panel using a 11/32 drill
bit. Secure the Base Plate to the trailer using a 2 X 5/16 coarse thread nut, bolt and washer set.
Repeat for all four corners and check nal tension on all fasteners.
Step 2: Attach the Upright Bars
Place the Uprights on the bracket as shown and secure using a 2 X 5/16 coarse
thread Nuts and Bolts and Washers.
Repeat for all sides and tighten.
Step 3: Attach the Overhead Rack Bar
Insert the Pin Nut in the hole on the top of the Upright. Place the Overhead Rack Bar in the grooves of the Uprights
with the hole facing downwards. Using 2.5 X 5/16 Fine Thread Nuts and Bolts secure it to the Uprights.
Repeat for all 4 corners.
Loading...