Lennox Hearth TAPD45C User Manual

LENNOX HEARTH PRODUCTS

KITS AND ACCESSORIES

750,200M REV. B 06/2006

DECORATIVE STYLE VIEW™ ARCH PANE SCREEN DOOR KITS

CHARCOAL & SATIN PEWTER

INSTALLATION INSTRUCTIONS FOR DECORATIVE TALL ARCH SCREEN PANEL KITS

FOR USE WITH MPB-35/40/45, MPD-35/40/45, MPB35ST, MPD35ST, EDV-35/40/45, SDDV-35/40, EDVST* & EBVST* GAS FIREPLACES

STYLE VIEW TALL ARCH PANE SCREEN DOOR KITS

CAT# MODEL DESCRIPTION

H3525 TAPD35C 35” Arch Pane, Charcoal

H3527 TAPD35SP 35” Arch Pane, Satin Pewter

H3529 TAPD40C 40” Arch Pane, Charcoal *

H3531 TAPD40SP 40” Arch Pane, Satin Pewter *

H3533 TAPD45C 45” Arch Pane, Charcoal

H3535 TAPD45SP 45” Arch Pane, Satin Pewter

H3537 TAPD35EC 35” Arch Pane, Charcoal

(SDDV-35 & EDV35 only)

H3539 TAPD35ESP 35” Arch Pane, Satin Pewter (SDDV-35 & EDV35 only)

Kit Contents

(see Table 2)

750,200M

DECORATIVE STYLE VIEW™ ARCH PANE SCREEN DOOR KITS

REV. NC 12/2005

CHARCOAL, TEXTURED IRON, SATIN PEWTER & ANTIQUE BRASS

INSTALLATION INSTRUCTIONS FOR DECORATIVE ARCH SCREEN PANEL KIT

FOR USE WITH LMDV-35/40/45, MPD-35/40/45, MPD35ST,

EDV-35/40/45, EDVST & EBVST GAS FIREPLACES

STYLE VIEW ARCH PANE SCREEN DOOR KITS

CAT# MODEL DESCRIPTION

Kit Contents

H3525 TAPD35C35” Arch Pane, Charcoal

(see Table 2)

H3526 TAPD35TI 35” Arch Pane, Textured Iron

H3527 TAPD35SP 35” Arch Pane, Satin Pewter

LENNOX HEARTH PRODUCTS KITS AND ACCESSORIES

750,200M

DECORATIVE STYLE VIEW™ ARCH PANE SCREEN DOOR KITS

REV. NC 12/2005

CHARCOAL, TEXTURED IRON, SATIN PEWTER & ANTIQUE BRASS

INSTALLATION INSTRUCTIONS FOR DECORATIVE ARCH SCREEN PANEL KIT

FOR USE WITH LMDV-35/40/45, MPD-35/40/45, MPD35ST, EDV-35/40/45, EDVST & EBVST GAS FIREPLACES

H3528 TAPD35AB 35” Arch Pane, Antique Brass

STYLE VIEW ARCH PANE SCREEN DOOR KITS

CAT#MODELDESCRIPTION

Kit Contents

H3525TAPD35C35” Arch Pane, Charcoal

(see Table 2)

4 H3526TAPD35TI 35” Arch Pane, Textured Iron

H3527TAPD35SP35” Arch Pane, Satin Pewter

H3528TAPD35AB35” Arch Pane, Antique Brass

H3529TAPD40C40” Arch Pane, Charcoal

H3530TAPD40TI 40” Arch Pane, Textured Iron

1 H3531TAPD40SP40” Arch Pane, Satin Pewter

H3532TAPD40AB40” Arch Pane, Antique Brass

H3533TAPD45C45” Arch Pane, Charcoal

Figure 1

H3534TAPD45TI45” Arch Pane, Textured Iron

H3535TAPD45SP45” Arch Pane, Satin Pewter

Read and understand all instructions and warnings in this docu-

H3529 TAPD40C40” Arch Pane, Charcoal

H3536TAPD45AB45” Arch Pane Doors, Antique Brass

ment before beginning the installation.

H3537TAPD35EC35” Elite Arch Pane, Charcoal

H3538TAPD35ETI35” Elite Arch Pane, Textured Iron

WARNINGS

H3539TAPD35ESP35” Elite Arch Pane, Satin Pewter

H3540TAPD35EAB35” Elite Arch Pane, Antique Brass

Hot! Do not touch! These decorative screen doors

are NOT heat guards.

Table 1

The ceramic glass behind the

and will retain

screens will be hot during operation

heat for a while after shutting off the appliance

KIT CONTENTS

Severe burns may result. Carefully supervise

ITEMQUANTITYDESCRIPTION

children in the same room as appliance.

11 ea.Door, Left

• As with any similar heating appliance, surfaces of the

21 ea.Door, Right

frame and doors including handles can become very

31 ea.Doorframe Assembly

hot. Avoid touching the glass or screen door surfaces

41 ea.Screen Panel, Lower

when operating the doors.

H3530 TAPD40TI 40” Arch Pane, Textured Iron

51 ea.Instruction Sheet

• Use care when opening doors . Avoid exerting any

Table 2 - Refer to Figure 1

downward pressure on the doors when they are in an

open position. Excessive force can cause the doors to

come loose or be damaged.

TOOLS REQUIRED

• The lower screen panel covering the controls will

None

become hot during operation. Use care when remov-

ing the panel to access the controls and make sure to

GENERAL INFORMATION

place the screen on a surface that is non-combustible

These decorative screen doors are offered in four attractive ﬁ nishes and

or will not be damaged by high temperatures.

ﬁ t on the face of the appliance over the glass doorframe. If you encounter any problems, need clariﬁ cation of these instructions or are not qualiﬁ ed to

• INSTALL ONLY WHEN THE FIREPLACE IS OFF AND COLD!

properly install this kit, contact you local distributor or dealer.

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

H3531 TAPD40SP 40” Arch Pane, Satin Pewter

H3532 TAPD40AB 40” Arch Pane, Antique Brass

H3533 TAPD45C45” Arch Pane, Charcoal

Figure 1

H3534 TAPD45TI45” Arch Pane, Textured Iron

H3535 TAPD45SP 45” Arch Pane, Satin Pewter

Read and understand all instructions and warnings in this docu-

H3536 TAPD45AB 45” Arch Pane Doors, Antique Brass

ment before beginning the installation.

H3537 TAPD35EC 35” Elite Arch Pane, Charcoal

H3538 TAPD35ETI 35” Elite Arch Pane, Textured Iron

H3539 TAPD35ESP 35” Elite Arch Pane, Satin Pewter

H3540 TAPD35EAB 35” Elite Arch Pane, Antique Brass

Hot! Do not touch! These decorative screen doors

Table 1

are NOT heat guards.

screens will be hot during operation

heat for a while after shutting off the appliance

KIT CONTENTS

Severe burns may result. Carefully supervise

ITEM QUANTITY DESCRIPTION

children in the same room as appliance.

1 1 ea. Door, Left

• As with any similar heating appliance, surfaces of the

2 1 ea. Door, Right

frame and doors including handles can become very

3 1 ea. Doorframe Assembly

hot. Avoid touching the glass or screen door surfaces

4 1 ea. Screen Panel, Lower

when operating the doors.

5 1 ea. Instruction Sheet

• Use care when opening doors . Avoid exerting any

Table 2 - Refer to Figure 1

downward pressure on the doors when they are in an open position. Excessive force can cause the doors to come loose or be damaged.

TOOLS REQUIRED

• The lower screen panel covering the controls will

None

become hot during operation. Use care when removing the panel to access the controls and make sure to

GENERAL INFORMATION

place the screen on a surface that is non-combustible

These decorative screen doors are offered in four attractive ﬁ nishes and

or will not be damaged by high temperatures.

ﬁ t on the face of the appliance over the glass doorframe. If you encounter any problems, need clariﬁ cation of these instructions or are not qualiﬁ ed to

• INSTALL ONLY WHEN THE FIREPLACE IS OFF AND COLD!

properly install this kit, contact you local distributor or dealer.

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

Figure 1

WARNINGS

LENNOX HEARTH PRODUCTS

The ceramic glass behind the

KITS AND ACCESSORIES

and will retain

Table 1

KIT CONTENTS

ITEM QUANTITY DESCRIPTION

1 1 ea. Door, Left

2 1 ea. Door, Right

3 1 ea. Doorframe Assembly

4 1 ea. Lower Compartment Cover

5 1 ea. Firebox Bottom Cover Panel

6 1 ea. Instruction Sheet

Table 2 - Refer to Figure 1

Read and understand all instructions and warnings in this document before beginning the installation.

Hot! Do not touch! and the glass behind the screen doors will become hot during operation heat for a while after shutting off the appliance Severe burns may result. Carefully supervise children in the same room as appliance.

• These decorative screen doors are NOT heat guards and are not intended to prevent burns.

• Operate the doors by only using the door handles. Avoid touching the doorframe, screens, or the glass enclosure, if the door is opened.

WARNINGS

The decorative screen doors

• The lower compartment cover will become hot during

TOOLS REQUIRED

5/16” Nutdriver or Socket 1/4” Nutdriver or Socket (for EDVST model only)

GENERAL INFORMATION

These decorative screen doors are offered in two attractive ﬁ nishes and ﬁ t on the face of the appliance over the glass doorframe. If you encounter any problems, need clariﬁ cation of these instructions or are not qualiﬁ ed to properly install this kit, contact you local distributor or dealer.

* Note: Early revisions of model EDVST and EBVST may also require a magnet

mounting kit, Cat. No. H2110. If the appliance does not have slots described in Step 5 (to accept the hinge tabs on style view doors), the tabs on the style view doorframe must be sawed off, then the doorframe will be secured to the glass door assembly using 4 magnets provided in the H2110 kit.

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

operation of the ﬁ replace. Use care when removing the panel to access the controls. Handle the compartment cover by grasping the two knobs mounted on the face of the cover panel.

• Be certain to place the control compartment cover panel on a surface that is non-combustible or will not be damaged by high temperatures.

• Use care when opening doors. Avoid exerting any downward pressure on the doors when they are in an open position. Excessive force can cause the doors to come loose or be damaged.

• INSTALL ONLY WHEN THE FIREPLACE IS OFF AND COLD!

and will retain

INSTALLATION INSTRUCTIONS:

1. Remove Top and Bottom Panels - a. Remove the top louvered or radiant panel/hood assembly by pulling

the assembly up and out (see Figure 2). In instances where the radiant panel is used and it is framed in with tile or other approved material, the hood must still be removed by ﬁ rmly pulling it forward until it releases from the receiving brackets.

b. Remove the bottom louvered or radiant panel/hood assembly (refer to

Homeowner’s Care and Operation Manual).

Remove Trim Panels as shown. The trim panels will be either

Louvered Panels or Radiant Panels.

a. Open the latch(es) at the bottom of the glass door assembly as shown

in Figure 4 (refer to Homeowners Manual).

b. Adjust glass door so that it is evenly spaced and aligned to the ﬁ replace

chassis on both sides. See Figure 4.

c. Fasten the latch(es). Ensure that the latch(es) are engaged with the

door’s vee-ﬂ ange and fully closed. See Figure 4.

Top Flange on Glass Door

Glass Door

Some models will have a modesty panel in the control compartment (in front of the valve). The appearance will vary from the example shown below.

Modesty Panel

Radiant Panels

Louvered Panels

Figure 2 - Remove Top Panel

c. Remove Bustles - Some models have bustles (as shown in Figure 3)

which must be removed. If applicable, remove the top and bottom bustle by lifting them up and out.

Only Some Models Have Bustles

Bustles

Lift Bustles Up And Off

Figure 3 - Remove Bustles

2. Align Glass Door (see Figure 4) - Ensure the glass door assembly on

the ﬁ replace is properly aligned as follows:

Note: Units with Modesty Panels - Remove the modesty panel,

if necessary, as follows: Lift the modesty panel by the tab on the panel’s right end, pull the right end of the panel away from cabinet and then pull the panel diagonally out of the corner post slots on the left side of the unit. Remove the modesty panel carefully, so that none of the wires become loose or disconnected.

Bottom Vee-ﬂ ange Glass Door

Glass Door Latch

Firebox Floor

Figure 4 - GLASS DOOR ADJUSTMENT

3. Install Firebox Bottom Cover Panel - For Models EDV-35/40/45, see

Figure 5a. For Model EDVST see Figure 5b.

For EDV-35/40/45 Models

Step 1 - Remove 2 ﬁ rebox bottom screws.

Step 2 - Install the Firebox Bottom Cover Panel (#5 in Figure 1) using the existing screws that were removed. The top two holes on the panel align to corresponding holes on ﬁ replace.

Screw

Figure 5a - Install Firebox Cover

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

+ 2 hidden pages