Lenco IPD-4100 User Manual

IPD-4100/2 Series iPod Speaker Dock with FM radio

User Guide

English

For information and support, www.lenco.eu

IMPORTANT: Please read all instructions carefully before use and keep for future reference

Thank you for choosing this Lenco iPod Speaker Dock with FM Radio. Not only can it receive
radio stations, but you can also listen to your favourite tracks on your iPod and charge it up.

It’s really simple to use; you can fully operate your iPod from the control panel on the top or
from the remote control, and even connect another auxiliary device to it.

Throughout this User Guide, the iPod Speaker Dock with FM Radio will be referred to as the
Speaker Dock.

Safety is important

Use of any electrical equipment should be undertaken with care. Please read the safety section on Page 15
before using your iPod Speaker Dock. This appliance is for household use only.

Ma de for

iPod

An audio system that allows docking of
an iPod and which fully supports the iPod
me nu system.

iPod Speaker Dock

Any iPod can be connected to the Speaker Dock, which allows all your songs to be played
through the speakers. The Speaker Dock features high quality speakers and a built in Subwoofer
to produce a high quality output. In addition, your iPod will charge while connected.

FM Radio

The Speaker Dock features an FM Radio allowing you to listen to all your favourite radio stations.
Up to 20 stations can be saved to memory for ease of use.

1

Power Adapter

2

DOC

EQ

FWD

MEM

MODE

ALARM

SLEEP/CLOCK

ARROW/RWD

TUNE

MEMORY CARD

POWER

TOP

UP

DOWN
ARRO
W/

3

MEMOR Y BATTERY

IPD-4100/2

FM: 87.5MHz - 1 08MHz
INPUT: DC 15V 2.0A

/

IMPEDANCE: 4c hannel

OUTPUT POW ER:10W * 2+20W
MAX. POWER CO NSUMPTION: 40 W

April 10

PRODUCTION D ATE: ,20
M A D E I N C H I N A

Compa rtment

MEMORY BAT TERY

ANT

SPEAKE R Port

ANT

DC IN

DC IN

RIGHT AUX Inpu t

AUX R

AUX L

SUB OUT

SUB

SUB Inp ut

SUB Ou put

LEFT AUX Input

4

1.Setting up the iPod Speaker Dock

Insert the Mains Plug into a suitable wall socket and turn the socket on.

Press the STANDBY button to turn the Speaker Dock on.

2.Using the Remote Control

The Remote Control can be used to operate the Speaker Dock. Before using the Remote Control,
the Safety Tab should be removed.

Simply pull out the Safety Tab from the remote control, as shown below.

To use the Remote Control, simply direct it towards the front of the Speaker Dock and press the

5