Swifts® cable ladder ancillary items
Hold down bracket
Nylon pad
Ø15 nylon bush
Nylon washer
Hold down bracket
40
B
A
3
One hole
Ø11
39
18
W
X
Y
hold down brackets and insulated hold down brackets
150125100
Hold down brackets are used for fixing cable ladder to cantilever arms,
trapeze hangers, Swiftrack channel or other flat support surfaces. They
can be fitted on the inside or the outside of the ladder rail
When used with other items from the Swifts range refer to the relevant
product page for specific orientation details
Supplied singly without fasteners
Insulated versions for stainless steel ladder are available, contact us on
+44 (0) 845 605 4333
Insulated hold down brackets are supplied with the required nylon
insulating pad, bush and washer
■ Installation (typical)
Standard hold down bracket
Ladder range
Topaz Sapphire Emerald
Standard hold down bracket
Insulated hold down bracket
Insulated hold down bracket
ZJF PJF EJF
ZJ INF PJ INF EJ INF
■ Assembly
Insulated hold down brackets are assembled as shown (typical) with
the nylon pad, bush and washer providing the required insulation.
Standard hold down brackets are assembled in the same way, but
without the insulating parts (bold type – see below)
Use M10 screw, nut and washers to suit the application (not included)
Use fasteners illustrated – only those shown in bold type are included
Stainless steel
hold down
bracket
M10 x 40 long
grade A4-70
stainless steel
setscrew
M10 grade A4
stainless steel
form A washer
■ Assembly
Standard hold down bracket
Insulated hold down bracket
■ Dimensions and weights
Weight
Cat. Nos. A B (kg)
ZJF 103 31 0·16
PJF 128 31 0·19
EJF 153 31 0·22
Weights
All weights given are in kilograms (kg) and are for hot dip
galvanised G finish
To obtain the appropriate component weight in other
finishes, multiply the given weight by the following factors :
Deep galvanised (D) x 1·07
Stainless steel (S) x 0·94
Powder coated (E) x 0·97
Nylon 66
insulating pad
M10 nylon 66
bush 7·5 long
M10 nylon 66
washer
Fixing hold down brackets to supports
All types of support from the Swifts range are provided with correctly
positioned fixing holes to accept hold down brackets without drilling.
The table contains data on fixing hole spacing required when attaching
hold down brackets to other supports
Centre distance between fixing holes
Cat. Nos. inside ladder outside ladder
ZJF W – 44 W + 80
PJF W – 44 W + 80
EJF W – 44 W + 80
W = ladder width
Key : Replace the letter shown in red with your choice from the
F = Finish : G (hot dip galvanised after manufacture)
following options :
D (deep galvanised)
S (stainless steel)
E (powder coated)
M10 grade A4
stainless steel
form A washer
M10 grade A4
stainless steel
spring washer
M10 grade A4-70
stainless steel
nut
Y
x
All dimensions (mm) are nominal
Cantilever arms : see p. 74
➔
Swiftrack channel support : see p. 99-108
➔
81
Loading...