Legrand RC7AP User Manual

RC7 P

oke-Thru Abandonment Plate

Cat. No. RC7AP

INSTALLATION INSTRUCTIONS

Walker®electrical systems conform to and should be properly grounded in compliance with requirements of the current National Electrical Code or codes administered by local authorities.

All electrical products may present a possible shock or fire hazard if improperly installed or used. Walker electrical products may bear the mark as UL Listed and/or Classified and should be installed in conformance with current local and/or the National Electrical Code.

Products Covered: RC7APBK and RC7APVY

Punch Out Center Hole

Remove Cover

Attach Plate Using Screw Provided

Step 2

Step 1

Step 3

Option 1 – With Receptacle In Place:

Walker Systems, Inc. 1000 Innovation Drive, Williamstown, WV 26187

Remove Cover, Receptacle and Receptacle Wires or Conduit Adapter Assembly

Punch Out Both End Holes

Place Intumescent Wafers

Step 1

Step 2

Step 3

Attach Plate Using Screws Provided

Step 4

Option 2 – With Receptacle Out: