Legrand NME1250AP User Manual

Legrand/Wiremold electrical systems conform to and should be
properly grounded in compliance with requirements of the current
National Electrical Code or codes administered by local authorities.

All electrical products may present a possible shock or fire
hazard if improperly installed or used. Legrand/Wiremold electrical
products may bear the mark of a Nationally Recognized Testing
Laboratory (NRTL) and should be installed in conformance with current
local and/or the National Electrical Code.

NME1250AP

Nonmetallic Wireless Access Point
Mounting Enclosure

I N S T A L L A T I O N I N S T R U C T I O N S

nstallation Instruction No.: ED1327R1 – Updated July 2010

I

CAUTION: To reduce the risk of electrical shock, always disconnect the network lines before servicing or disassembling this equipment.

IMPORTANT: Please read all instructions

before beginning.

Step 1 Step 2

Open

Step 3 Trim around opening. Step 4

Knife (Not included)

Raceway

Access Point

#10 Screw (Included)

#10 Wall Anchor

(Included)

Step 5

Cisco®Router

NOTE: Wireless Access Device not included.

Mount Screws

Step 6 Step 7

Close

Hook and Loop Straps

for other routers

Secure unit closed with

supplied key lock or #6 screw

© Copyright 2010 Legrand/Wiremold All Rights Reserved

Wiremold

U.S. and International:

60 Woodlawn Street • West Hartford, CT 06110
1-800-621-0049 • FAX [phone] • Outside U.S.: 860-233-6251

Canada:

570 Applewood Crescent • Vaughan, Ontario L4K 4B4
1-800-723-5175 • FAX [phone]

ED1327R1 0710