
5739 62/63
Multimedia Touch Screen
Installation Manual
Part. U3571A - 09/09-01 PC

Installation Manual
3
Contents
Multimedia Touch Screen
1 Introduction 4
1.1 Warnings and recommendations 4
1.2 Box contents 4
2 Description 5
2.1 Front view 5
2.2 Rear view 6
3 Installation 7
3.1 Cover Plate Fitting 7
3.2 Wall installation with metal bracket supplied 8
3.3 Battery replacement 11
4 Configuration 12
4.1 Configuration via Software 12
4.2 PC connection 12
5 Appendix 14
5.1 Technical data 14
5.2 Dimensions 14

1.1 Warnings and recommendations
1 Introduction
Before proceeding with the installation, please make sure you read the following manual carefully.
The warranty is immediately invalidated in case of negligence, improper use or tampering by
unauthorised personnel.
The Multimedia Touch Screen:
must be installed only indoors;•
must not be exposed to dripping or splashing of water;•
must be used exclusively on Legrand 2 wire digital systems.•
1.2 Box contents
The box contains:
Multimedia Touch Screen;•
metal bracket for wall installation;•
installation manual;•
user manual;•
CD;•
display cleaning cloth;•
1 x 512 MB SD card.•

Multimedia Touch Screen
Installation Manual
5
2.1 Front view
WebCam USB port (future application)1 -
Microphone2 -
USB ports for USB PenDrive and Dongle Wi-Fi (future application)3 -
Mini-USB port for PC connection4 -
Secur Digital memory card port (max 2 GB no HC–SD)5 -
1 2
3
45
2 Description

2.2 Rear view
Port for Sound System source output1 -
RJ45 port for Ethernet connection2 -
LAN connection LEDs3 -
PSTN telephone line port (future application)4 -
Video 2 wire SCS BUS port5 -
Power supply 1-2 port6 -
End-of-line ON/OFF micro-switch7 -
Stereo loudspeakers8 -
Bracket fastening screw9 -
Factory settings reset pushbutton10 -
Battery compartment11 -
RS232 port for PC connection12 -
PSTN
BUS 2 1
ON
OFF
ETH
SCS AUDIO OUT
11
1 2 3 4
88 910
5 6
12
7

3.2 Wall installation with metal bracket supplied
3 Installation

Multimedia Touch Screen
Installation Manual
9
Make sure the nut is positioned at the bottom end
If the Multimedia Touch Screen
is the last component on the
line move the micro-switch to
the ON position
Additional power supply via terminals 1 – 2 is required: take care not to invert polarity.
PSTN
BUS 2 1
ETH
SCS AUDIO OUT
PRI: 220 – 240 V~
175 – 165 mA
47/63 Hz
SCS: 27 Vdc
600 mA
035 84
634 42
634 35
230 Vac
ETHERNET
cable
audio SCS/BUS

To complete the installation, turn the
fastening screw underneath the Multimedia Touch Screen anticlockwise
3 Installation

Multimedia Touch Screen
Installation Manual
11
3.3 Battery replacement
NiMh: 7,2 V; 160 mAh
Ni MH
After removing the cover, insert the battery as shown below:

4.1 Configuration via Software
4.2 PC connection
To receive / transfer the configuration entered via the MultimediaTouchScreenConfig software or
perform a firmware update, connect the Multimedia Touch Screen to the PC using a USB/miniUSB
cable or the serial port (492 34) or an Ethernet cable.
USB Connection
4 Configuration
The Multimedia Touch Screen can be configured via the MultimediaTouchScreenConfig software
supplied.

5.1 Technical data
5.2 Dimensions
5 Appendix
309
233
30
Local power supply (1 – 2) 18 – 27 Vdc
BUS/SCS power supply 18 – 27 Vdc
Maximum local absorption (1 – 2) 600 mA
Maximum absorption from BUS/SCS 50 mA
Operating temperature 5 – 45 °C

Legrand reserves at any time the right to modify the contents of this booklet and to communicate, in any form
and modality, the changes brought to the same
World Headquarters and
International Department
87045 LIMOGES CEDEX FRANCE
: 33 5 55 06 87 87
Fax : 33 5 55 06 74 55
www.legrandelectric.com
Installer stamp