LEGRAND Kenall SENSCAPE SPG18 Installation Instructions Manual
SENSCAPE™ SPG18
Conduit hub (by others)
Conduit body and
Conduit (by others)
Figure 1 Figure 2
INSTALLATION INSTRUCTIONS
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed, including the following:
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION
CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED. DISCONNECT POWER TO ALL CIRCUITS BEFORE WIRING FIXTURE. INSTALL IN
ACCORDANCE WITH ALL NATIONAL, STATE, AND LOCAL CODES. DO NOT CONNECT TO AN UNGROUNDED SUPPLY. READ ALL
FIXTURE MARKINGS AND LABELS TO ENSURE CORRECT INSTALLATION OF FIXTURE. SUPPLEMENTAL INSTRUCTIONS MAY BE
LOCATED ON THE FIXTURE, IN ADDITION TO THIS INSTRUCTION SHEET, REGARDING ORIENTATION, OR MOUNTING RESTRICTIONS.
CE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE CODE D’INSTALLATION PERTINENT, PAR
UNE PERSONNE QUI CONNAÎT BIEN LE PRODUIT ET SON FONCTIONNEMENT AINSI QUE LES
RISQUES INHÉRENTS.
THE DOWNLIGHT CONTAINS SENSITIVE ELECTRONICS. TAKE CARE TO AVOID DAMAGE BY IMPROPER HANDLING OR STATIC
ELECTRICITY DISCHARGE (ESD). EITHER TYPE OF DAMAGE COULD RENDER THE SYSTEM INOPERABLE OR CAUSE LATENT FAILURE.
SAVE THESE INSTRUCTIONS
Trunnion Kit
1. Assemble trunnion kits as shown using (4) ¼ - 20 x .500" screws, washers, and nuts (provided). Shown in Figure (1).
2. Attach trunnion brackets to trunnion box shown on the top of the xture with (4) 10-32: hex nuts (provided). Shown in
Figures (1 & 2).
1
3. Install 3/4" NPT conduit hub (supplied by others) into trunnion box.
4. Make electrical connections in conduit body (supplied by others).
www.kenall.com | P: 800-4-Kenall | F: 262-891-9701 | 10200 55th Street Kenosha, Wisconsin 53144, USA
This product complies with the Buy American Act: manufactured in the United States with more than 50% of the component cost of US origin. It may be covered by patents
found at www.kenall.com/patents. Content of specication sheets is subject to change; please consult www.kenall.com for current product details. ©2019 Kenall Mfg.Co.
SPG18_TK_F-6636_121619
INSTALLATION INSTRUCTIONS
SAFETY RECOMMENDATION
Safety Recommendation: A 1/16" diameter cable with end-loop (not included) is recommended for attaching the
xture structural to the upper structural.
Aircraft cable.
Attach to upper
structural.
1/16" dia. aircraft cable
(supplied by others)
Screw
(supplied by others)
2
CUSTOMER SERVICE
For technical assistance, call 1-800-4KENALL (1-800-453-6255). For additional instructions,
go to www.kenall.com/Installs
WARRANTY
For warranty information visit www.kenall.com/Resources/Certied-Performance-Warranties
www.kenall.com | P: 800-4-Kenall | F: 262-891-9701 | 10200 55th Street Kenosha, Wisconsin 53144, USA
This product complies with the Buy American Act: manufactured in the United States with more than 50% of the component cost of US origin. It may be covered by patents
found at www.kenall.com/patents. Content of specication sheets is subject to change; please consult www.kenall.com for current product details. ©2019 Kenall Mfg.Co.
SPG18_TK_F-6636_121619
Loading...