Legrand IS-0291 User Manual

INSTRUCTION/INSTALLATION SHEET
SURGE PROTECTED OUTLET KIT

301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone [phone] / Fax [phone]
www.onqlegrand.com

1. Introduction

The On-Q/Legrand Surge Protected Outlet Kit, P/N 364569-02,
provides the option of mounting a surge protected 120VAC outlet
into an On-Q Service Center Enclosure. The kit consists of a
surge protected duplex receptacle outlet, metal receptacle box,
cover plate, and 4 mounting screws (see Figure 1).

2. Description

The Surge Protected Outlet Kit protects connected loads from
potentially damaging voltage spikes (surges) caused by lightning
strikes, or the switching of inductive loads (motor loads), as well
as from RFI (radio frequency interference). It cannot provide
protection in the rare event of a direct lightning strike. An audible
signal will alert you to the failure of the surge protection
component. If audible signal is activated, the device has received
power surges beyond its capacity and is no longer functioning as
a surge protector. The alarm can be deactivated by unplugging
the Surge Suppressor Module (see Figure 2). Replace with a
new Surge Suppressor Module, P/N 364767-01, to restore surge
protection.

3. Installation

A. Remove knockout metal on bottom right of enclosure (see

IS-0291 REV. B

Figure 1

Insert small
screwdriver into
slot and lift out

Figure 3).

B. Insert metal receptacle box and secure with sheet metal

screws.
C. Route NM cable to receptacle box and secure.
D. Conne ct duplex outlet and secure to metal receptacle box.
E. Install outlet face plate.

NOTE: The Surge Protected Outlet Kit, PN 364569-02,
contains outlets positioned in such a manner as to possibly
prevent power transformers from properly fitting within the
confines of the enclosure. The power transformer may be
restricted by the enclosure door or the rear wall of the
enclosure.
Use a Surge Protected Outlet Kit and one or two Power Strip Modules, PN 364266-01. Or, use a Duplex
Outlet Power Kit, PN 364569-01, with one or two Surge Protected Power Strip Modules, PN 364771-01.
See Technical Bulletin TB-0010.

Page 1 of 1

©Copyright 2006 by On-Q/Legrand All Rights Reserved.

Figure 2

Figure 3