LEGRAND CHIEF FCAVCU20 Installation Instructions Manual

Page 1
I N S T A L L A T I O N I N S T R U C T I O N S
2" U-Bolts
Spanish Product Description German Product Description
Portuguese Product Description
Italian Product Description
Dutch Product Description
FCAVCU20
Page 2
FCAVCU20 Installation Instructions
DISCLAIMER
Legrand | AV and its affiliated corporations and subsidiaries (collectively “Legrand | AV”), intend to make this manual accurate and complete. However, Legrand | AV makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use of this product. The information contained in this document is subject to change without notice or obligation of any kind. Legrand | AV makes no representation of warranty, expressed or implied, regarding the information contained herein. Legrand | AV assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
DEFINITIONS
MOUNTING SYSTEM: A MOUNTING SYSTEM is the
primary Chief product to which an accessory and/or component is attached.
ACCESSORY: AN ACCESSORY is the secondary Chief
product which is attached to a primary Chief product, and may have a component attached or setting on it.
COMPONENT: A COMPONENT is an audiovisual item
designed to be attached or resting on an accessory or mounting system such as a video camera, CPU, screen, display, projector, etc.
follow all instructions can result in serious personal injury, damage to equipment, or voiding of factory warranty! It is the installer’s responsibility to make sure all accessories are properly assembled and installed using the instructions provided.
WARNING: Failure to provide adequate structural strength
for this accessory can result in serious personal injury or damage to equipment! It is the installer’s responsibility to make sure the structure to which this accessory is attached can support five times the combined weight of all equipment. Reinforce the structure as required before installing the accessory.
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the installer’s responsibility to make sure the combined weight of all components attached to accessory does not exceed the weight limit of the mount to which it is attached.
WARNING: Use this accessory only for its intended use as
described in these instructions. Do not use attachments not recommended by the manufacturer.
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the corresponding instructions.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: Failure to read, thoroughly understand, and
DIMENSIONS
WARNING: Never operate this accessory if it is damaged.
Return the accessory to a service center for examination and repair.
WARNING: Do not use this accessory outdoors.
IMPORTANT ! :
mounted to a 2" diameter aluminum column.
The FCAVCU20
accessory
is designed to be
--SAVE THESE INSTRUCTIONS--
2
Page 3
Installation Instructions FCAVCU20
TOOLS/PARTS REQUIRED FOR INSTALLATION
B (4)
1/2" (12.7mm)
A (2)
[2" U-Bolt bracket with hex nuts]
.750x.350x.060
Assembly And Installation
1. Remove two hex nuts and pole bracket from each 2" U-Bolt bracket (A). (See Figure 1)
(pole bracket)
(need to separate)
1
Figure 1
2. Use removed hex nuts and .750x.350x.060 spacers (B) to secure FCAVCA faceplate (not included) to pole. Tighten to a torque rating of 250 inch-pounds. (See Figure 2)
2
FCAVCA
(not included)
x 4
(B) x 4
(A) x 2
(separated)
Figure 2
3
Page 4
FCAVCU20 Installation Instructions
8800-003127 Rev00 2019 Legrand | AV
www.legrandav.com
03/19
USA/International A 6436 City West Parkway, Eden Prairie, MN 55344
P 800.582.6480 / 952.225.6000 F 877.894.6918 / 952.894.6918
Europe A Franklinstraat 14, 6003 DK Weert, Netherlands
P +31 (0) 495 580 852 F +31 (0) 495 580 845
Asia Pacific A Office No. 918 on 9/F, Shatin Galleria
18-24 Shan Mei Street
Fotan, Shatin, Hong Kong
P 852 2145 4099 F 852 2145 4477
Loading...