Legrand 895 User Manual

895/896 Series
Floor Box Covers

INSTALLATION INSTRUCTIONS

Installation Instruction No.: 1 003 789 R1 – Updated August 2005

Walker®electrical systems conform to and should be properly
grounded in compliance with requirements of the current National
Electrical Code or codes administered by local authorities.

All electrical products may present a possible shock or fire
hazard if improperly installed or used. Walker electrical products
may bear the mark as UL Listed and/or Classified and should
be installed in conformance with current local and/or the National
Electrical Code.

Products Covered: 895DCC, 895, 895T, 895SP, 895TSP, 895P, 895GFI, 895TGFI, 896CK, 896TCK, 896PCK, 895TAL, 895TCAL, 895GFICAL,

895TGFIAL, 895SPCAL, 895TSPAL, 896CKAL-1/2, and 896TCKAL-1/2 Covers

IMPORTANT: Please read all instructions

before beginning.

881 PVC Floor Box Applications:

Step 1 Remove protective concrete

cap from box.

Step 2 For dual service applications, slide

partition onto the slots located on
the inside of the box and mark the
partition 2

" [50mm] below the top

of the box. Volume of power
compartment is reduced by
the first legible calibration.

Step 3 Remove the partition and break off

the top portion at the first calibration
below the mark made from step 2.
Reinstall the partition with the
small compartment being the
communications side.

Cover Attachment:

Step 4 Attach receptacle to cover adapter and wire the device.

Cat. No. 895DCC

(Shown)

Step 5 Place the gasket support plate over the receptacle and

attach with a #6 round head screw.

Step 6 Place the gasket over the support plate and attach the

cover with (3) #8 flat head screws.

Step 7

Remove 1/2" trade size screw plug and pull communication
cables through the opening (895DCC only). Complete
installation by aligning the adapter with the box grooves
in the box and push into place – No glue required!

© Copyright 2005 Wiremold / Legrand All Rights Reserved

NOTE: Keep screw plugs for

future abandonment.

880 Series Floor Box Applications:

Step 1 Remove the mud cap and

adjust the floor plate to be
1/8

" [3.2mm] below the final

floor finish.

Step 2 Place the gasket over the floor

plate and attach the cover using
(3) #8 flat head screws.

Step 3 Remove the center screw

plug and pull cables through
the opening.

Cat. No. 896CK

(Shown)

Step 1 Remove any plaster ears before wiring and attaching

the receptacle.

Cover Attachment:

Step 2 Place the gasket support plate over the receptacle and

attach with #6 round head screw.

Step 3 Place Gasket over the gasket support plate. Step 4 Attach cover with (3) #8 flat head screws. Complete

installation by pushing the box assembly into the
hole until seated firmly against the floor finish.

Cat. No. 895T

(Shown)

860 Series Floor Box Applications:

Wiremold / Legrand

U.S. and International:
60 Woodlawn Street • West Hartford, CT 06110
1-800-621-0049 • FAX [phone] • Outside U.S. 860-233-6251
Canada:
570 Applewood Crescent • Vaughan, Ontario L4K 4B4
1-800-723-5175 • FAX [phone]

1 003 789 R1 – Updated August 2005 – For latest specs visit www.wiremold.com