Legrand 363292-01 User Manual

Using the Punch & Go Tool

1. ITEMS NEEDED

Legrand Products:

363292-01 - Cat 5 Strip and Fit Tool

AC3400 - Punch & Go Tool

WP3475-WH - Cat 5 Quick Connect RJ45

Keystone Connector

2. INTRODUCTION

A structured wiring foundation is

the most effective way to distribute

information throughout a home. It

supports high-performance technology

through clutter-free cabling hidden

behind the walls. To ensure more

efficient installation, run a single home

run to a central distribution point and

bundle cables for access to multiple

services.

3. HOW TO STEP-BY-STEP

TOOLS & ADDITIONAL SUPPLIES:

• Wire Cutter

• Continuity Tester

• Cat 5 Cable

• RJ45 Jumper Cable

There are several fundamentals to
remember when working with Cat 5:

• On-Q products utilize the T568A wiring
standard

• Never splice Cat 5 cable

• Always maintain a 12-inch minimum
separation between the Cat 5 and any
120 Volt AC cabling. If you must cross
and electrical circuit, do so at a 90
degree angle

• Always maintain a minimum bend
radius of 1 inch.

• Never exceed the 25 pound pull limit.
Doing so may pull the twists out of
the wire, which is what gives Cat 5 its
immunity from interference. For the
same reason, you shouldn’t stand on
the wire or use any retention devices
that flatten out the wire.

STEP 1

Use the Strip and Fit tool to cut off
approximately two inches of the
jacket.

STEP 2

Cut the wire separator strands, separate
the pairs and untwist them.

STEP 3

Now fan them out in the T568A pattern.
White/Green
Green
White/Orange
Blue
White/Blue
Orange
White/Brown
Brown

www.legrand.us/onq

Using the Punch & Go Tool

3. HOW TO STEP-BY-STEP CONT.

STEP 4

Place the fanned wires into the
appropriate color coded terminals and
press until fixed.

STEP 5

Insert the connector using the guide rails
on either side of the Punch & Go tool and
the connector.

STEP 6

Firmly compress the handle of the
Punch & Go tool to terminate and cut
excess wire.

STEP 7

Place the cap on the back of the
connector and press to make sure it is
fully seated.

STEP 8

We recommend that you always test for
continuity. After placing your completed
connector into the wall, plug a short
RJ45 jumper cable into the connector.
Plug the other end of the jumper cable
into the tester.

301 Fulling Mill Road, Suite G

Middletown, PA 17057

[phone]

©2012 by Legrand. All Rights Reserved.

STEP 9

Place the other tester at the end of the
connector cable (at the enclosure) and
look for the green light.

www.legrand.us/onq