Legrand 2410D User Manual

2410D

Divided Entrance End Fitting

INSTALLATION INSTRUCTIONS

Installation Instruction No.: 1 007 122 – October 2007

Wiremold/Legrand electrical systems conform to and should be
properly grounded in compliance with requirements of the current
National Electrical Code or codes administered by local authorities.

All electrical products may present a possible shock or fire
hazard if improperly installed or used. Wiremold/Legrand electrical
products may bear the mark as UL Listed and/or Classified and should
be installed in conformance with current local and/or the National
Electrical Code.

IMPORTANT: Please read all instructions

before beginning.

1. Slide the tab on the divider into the slot on the
Entrance End Fitting base.

2. Slide the tongue on the Entrance End Fitting
base into the 2400D Raceway Base.

3. Attach Entrance End Fitting to the wall using #8 (5/16"
[7.9mm] head size) flat head fasteners or equivalent.

4. Slide the Raceway Cover into the slot on the Divider
and snap the Cover onto the Raceway Base.

Wiremold / Legrand

U.S. and International:
60 Woodlawn Street • West Hartford, CT 06110
1-800-621-0049 • FAX [phone] • Outside U.S.: 860-233-6251
Canada:
570 Applewood Crescent • Vaughan, Ontario L4K 4B4
1-800-723-5175 • FAX [phone]

1 007 122 1007

© Copyright 2007 Wiremold / Legrand All Rights Reserved

5. Place the Cover on the Entrance End Fitting and

tighten the screws.