Lefroy Brooks Y1-1009 Installation Manual

INSTALLATION INSTRUCTIONS

Y1-1009

CLICK-UP BASIN WASTE

What you need to know

Tools: Maintenance

Adjustable Wrench
Groove Joint Pliers
Hacksaw
Phillips Screwdriver
Pipe Tape
Spatula
Spirit Level

Safety Tips

If you are soldering during faucet installation,
remove cartridges, seats, gaskets and washers
prior to applying flame, otherwise you will void
the warranty.

Cover drain openings to avoid losing small parts.

When cutting or soldering pipe, use safety glasses
to protect your eyes.

Your new bathroom faucet is designed for years
of trouble-free performance.

Keep it looking new by cleaning it periodically with
a soft cloth. Avoid abrasive cleaners, wire wool and
harsh chemicals as these will dull the finish and
void your warranty.

Important Points

Prior to beginning installation. turn off the cold and
hot water lines and open the old faucet to release
built-up pressure.

Overtightening nuts may cause damage.

Wrap all threaded connections with pipe tape
available at your local plumbing supply store.
Always wrap in a clockwise direction. The fittings
should be installed by a state-licenced plumber.

Things You May Need

Correct installation may vary depending on previous faucet installation. All necessary supplies required for
faucet installation are not included, but may be found where plumbing supplies are sold. It is suggested that
IAPMO and/or CSA approved plumbing supplies are used during installation.

Standards

Meets A112.18.1

2