Lefroy Brooks R1-4002 Installation Manual

Dimensions

1/2"-14NPT

in Inches (& Millimetres)

5 1/8"

(130mm)

1 11/16"

(43mm)

3 15/16"

(100mm)

6 1/4"

(158mm)

(21mm)

13/16"

1/2"-14NPT

2 3/4"

(70mm)

5 3/16"

(134mm)

2 15/16"~3 15/16"

(75~100mm)

1/2"-14NPT

(62mm)

2 7/16"

1/2"-14NPT

Whilst every effort is made to ensure accuracy, design and dimensions are subject to
change without notice as part of the company’s product development process.

2

2 15/16"

(75mm)

What you need to know

Tools: Maintenance

Adjustable Wrench
Groove Joint Pliers
Hacksaw
Phillips Screwdriver
Pipe Tape
Spatula
Spirit Level

Safety Tips

If you are soldering during faucet installation,
remove cartridges, seats, gaskets and washers
prior to applying flame, otherwise you will void
the warranty.

Cover drain openings to avoid losing small parts.

When cutting or soldering pipe, use safety glasses
to protect your eyes.

Your new bathroom faucet is designed for years
of trouble-free performance.

Keep it looking new by cleaning it periodically with
a soft cloth. Avoid abrasive cleaners, wire wool and
harsh chemicals as these will dull the finish and
void your warranty.

Important Points

Prior to beginning installation. turn off the cold and
hot water lines and open the old faucet to release
built-up pressure.

Overtightening nuts may cause damage.

Wrap all threaded connections with pipe tape
available at your local plumbing supply store.
Always wrap in a clockwise direction. The fittings
should be installed by a state-licenced plumber.

Please note:
When there is a difference in water pressure between
hot and cold supplies to the mixing valve, the pressures
should by equalized by a plumber in accordance with
best practice and legislation.

Things You May Need

Correct installation may vary depending on previous faucet installation. All necessary supplies required for
faucet installation are not included, but may be found where plumbing supplies are sold. It is suggested that
IAPMO and/or CSA approved plumbing supplies are used during installation.

Standards Flow Rate

IAPMO/cUPC Listed
Meets A112.18.1
Meets ASSE 1016

Please note :
Final achievable flow rate is dependent on the outlets fitted, see relevant outlets (spouts, roses, sprays) for fully
assembled product flow rate.

9
7
5
3
1

20 40 60 80PSI

3