LBL Lighting Miss Charlie User Manual

Installation Instructions for

980MSCHARS

Miss Charlie Suspension

Suspension

GENERAL PRODUCT INFORMATION:

This product is suitable for damp locations.

This product can be dimmed with a standard incandescent dimmer.

CAUTION - RISK OF FIRE

This product requires installation by a qualified
electrician. Before installing be sure to read all
instructions and TURNTHE POWER TO THE
ELECTRICAL BOX OFF.

LF676_2D

1.0

Prepare the Fixture

Install Extension Stem (Optional)

1A 2A

SCREW

1

Separate the crossbar from the canopy by removing all
four screws with the provided Allen wrench.

ALLEN

WRENCH

EXTENSION STEM

1B

SOCKET ASSEMBLY

#8-32 SCREW

CANOPY

STEM

THREADED NIPPLE

THREADED NIPPLE

CROSSBAR
ASSEMBLY

2

Mount the crossbar to the electrical box with the two
#8-32 screws provided.

1

Temporarily remove the socket assembly by unscrewing and
pulling the fixture wires through.

22

Feed the fixture wires through the extension stem(s) and
tighten completely to the threaded nipple socket assembly.

23

Feed the fixture wires through the stem and out the canopy,
then screw the canopy/stem assembly to the extension
stem/socket assembly.

1

Install the Fixture

3A

CAUTION: To reduce the risk of a burn or electric
shock during relamping, disconnect the power to
the fixture.

Use
Type A19 Medium Base Lamp.

2

1

Screw all four lamps into the sockets.

120 voltMAX 75 Watt

3B

AIRCRAFT
CABLE

CABLE
CLUTCH

3C

6

LAMPSOCKET

26

Connect the fixture to a suitable ground in accordance

7

8

with local electrical codes.

27

Connect the black fixture wire to the hot power line wire
with a wire nut.

Connect the white fixture wire to the neutral power line

28

wire with a wire nut.

3D

SHADE

NOTE: Make sure to support the shade while

adjusting the aircraft cables. An assistant is
recommended to complete the remaining steps.

22

Feed the aircraft cables through the cable clutches in
the canopy.

3

2

Pull the aircraft cable up through the canopy to raise
the shade. Make sure that the shade is at least 3.5”
away from the lamp, but high enough to cover the
lamps.

2

4

To lower the shade, push the cable clutch in and pull the
aircraft cable down.

5

2

When the shade is in the desired position, trim the
excess aircraft cable.

NOTE: To replace the lamps, simply reach the lamp

from top of the glass shade. DO NOT REMOVE THE
SHADE.

SCREW

29

Place all wire and wire nut connections inside the

ALLEN

WRENCH

canopy.

210

Align the canopy holes with the crossbar holes. Secure
the canopy in place by tightening the four screws with
the provided Allen wrench.

SAVE THESE INSTRUCTIONS!

7400 Linder Ave, Skokie, IL 60077

800.323.3226 - 847.626.6300

www.lbllighting.com

© 2012 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.

2

A Generation Brands Company