LBL Lighting Mia WCF User Manual
Installation Instructions for
980MIABWCF
Mia Bath (Compact Fluorescent)
Wall
GP I :ENERAL RODUCT NFORMATION
This product can mount to either a 4" square electrical box with
round plaster ring or an octagon electrical box.
This product is suitable for indoor damp locations.
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
PW486O_14L
1.1
Prepare the fixture for Installation
1A 1B
THUMB SCREW THUMB SCREW
1 1
1
Loosen (do not remove) the two thumb screws on the top of
the fixture.
2
BACKPLATE
2
GLASS SHADE
Carefully remove the glass shade from the backplate.
1
Install the Mounting Plate
Install the Backplate
2A
INNER THREADED HOLE
SHORT #8-32
SCREW
1
Make sure the two inner threaded holes on the mounting
plate are positioned vertically.
NOTE: For vertical installation the inner threaded holes
must be in horizontal position.
Line up two mounting plate slots with the two electrical box
2
holes.
3
Level the mounting plate vertically and secure it to the
electrical box with the two short #8-32 screws provided.
MOUNTING PLATE
1
3
INNER THREADED HOLE
3
1
4A
LONG #8-32 SCREW
2
2
1
Line up the two backplate slots with the two mounting plate
inner threaded holes.
2
Level the backplate horizontally and secure it to the electrical
box with the two long #8-32 screws provided.
Install the Lamp
5A
Connect the Power
3A
3
4
1
Turn the power to the electrical box off.
2
Make sure that the mounting plate is grounded in accordance
with local electrical codes.
3
Connect the black fixture wire to the hot power line wire with
a wire nut.
4
Connect the white fixture wire to the neutral power line wire
with a wire nut.
1
2
Use Watt typeT5 Linear fluorescent lamp.Max 14
1
Line up the lamp pins on both sides with the opening on the
sockets.
Insert the pins all the way into the sockets and turn the lamp
2
to lock it in place. Repeat this step for the other lamp.
Properly place all wires into the electrical box.
5
2
Loading...