LBL Lighting Merlino Swivel II User Manual

Installation Instructions for

980FSJMRLSII

Merlino Swivel II

Fusion Jack™

GP I :ENERAL RODUCT NFORMATION

This product is ETL listed and suitable only for indoor dry locations
and approved for use at any height above the finished floor.

WARNING: Risk of Fire. Hot Surface. Install the fixture

at least 6" (Inches) away from wall, curtains and combustible
materials. Maintain at least 9" (Inches) of clearance directly in
front of the fixture.

AVERTISSEMENT: Risque du feu. Surface Chaude.

Installez le montage au moins 6" (Pouces), 153 mm, loin du
mur, des rideaux et des matériaux combustibles.Maintenez au
moins 9" (Pouces), 230 mm, de dégagement directement
devant le montage.

HA300FRSC_1A50FSJ

CAUTION - RISK OF FIRE

This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.

Use minimum 90°c supply conductors.

1.3

Install the Lamp and Shade

1A

NOTE:To reduce the risk of a burn or electric shock

during relamping, disconnect the power to the fixture.

Use Watt MR16 Front Cover

MAX 50

Halogen Lamp.

SOCKET

LAMP

1B

THUMB SCREW

3

Remove the three thumb screws.

33

1

Align the lamp pins with the socket holes.

2

Push the lamp pins completely into the socket holes.

1

1C

SOCKET POST

THUMB
SCREW

4

4

GLASS
SHADE

SAVETHESE INSTRUCTIONS!

4

Align the glass shade holes with the socket posts. Tighten the
three thumb screws to the bracket holes to secure the glass
shade in place.

7400 Linder Ave, Skokie, IL 60077

800.323.3226 - 847.626.6300

www.lbllighting.com

© 2014 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.

2

A Generation Brands Company