Page 1
Installation Instructions for
980FSJLEDP
LED Pendants
Fusion Jack™
GP I :ENERAL RODUCT NFORMATION
This product is ETL listed and suitable only for indoor dry locations
and approved for use at any height above the finished floor.
Adjust the Fixture Height
Fusion Jack LED Pendants
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1.2
1A
(H)
FIXTURE COAXIAL
CABLE
SOCKET ASSEMBLY
1B
ALLEN WRENCH
SET SCREW
CONNECTOR
3
Back out (do not remove) the set screw on tip of the
connector with the provided Allen wrench.
1C
ALLEN WRENCH
SET SCREW
4
3
1
Feed the fixture coaxial cable through the glass shade. Slide the
glass shade down the cord and rest it onto the socket
assembly.
2
Cut the coaxial cable to the desired length.
4
Back out (do not remove) the set screw on the conical
connector with the provided Allen wrench.
1
Page 2
1D
5
5
Gently twist the end of the coaxial cable between thumb and
forefinger.
1E
SURFACE
PLATE
6
Tap the conical connector on a hard surface with the set screw
facing down, so the plate inside drops into place.
1H
ALLEN WRENCH
9
Look into the sight hole on the top of the connector to make
INNER WIRE
SIGHT HOLE
10
sure that the inner wire is contacting the end of the connector.
10
Hold the coaxial cable in place and tighten the set screw on tip
of the connector with the provided Allen wrench. Make sure
this set screw connection is tight.
1I
11
9
1F
7
CONICAL CONNECTOR
7
Feed and push the coaxial cable into the conical connector.The
coaxial cable will come to a stop point after being inserted
3/4" into the conical connector.
1G
8
WRINKLE ON OUTER
WRAPPED WIRE
8
Keep pushing the coaxial cable into the connector while
rotating the connector to ease feeding the inner wire into the
tip of the connector.The outer wrapped wire will start
wrinkling while being inserted another 1/2" into the connector.
OUTER WRAPPED
WIRE STOPS HERE
INNER WIRE
STOPS HERE
11
Firmly tighten the set screw on the conical connector.
1J
12
12
Pull the coaxial cable toward the fixture to smooth the
wrinkles.
2
Page 3
Replacing the Lamp
2A 2C
SHADE
SOCKET
2
NOTE:To reduce the risk of a burn or electric shock
during relamping, disconnect the power to the fixture.
1
If necessary, slide the stem up.
2
Lift the shade up to expose the socket.
2B
2C
4
The lamp is rated at 6 watts at 12 volts.
4
Screw the new lamp into the socket.
2D
SHADE
3
LAMP
NOTE:Use only your fingers to replace the lamp.
3
Unscrew the old lamp.
5
Lower the shade onto the socket assembly.
6
If necessary, slide the stem back down in place.
3
Page 4
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
4
Loading...