Installation Instructions for
60 Watt Electronic Flexible Power Feed
980MRLSFELEDFCT-LED
CanopyTransformer
LED-Illuminated Monorail
GP I :ENERAL RODUCT NFORMATION
This product is ETL listed only when all the products used are
supplied by LBL Lighting, is suitable only for indoor dry locations
and approved for use at any height above the finished floor.
This product may be dimmed only with a low voltage electronic
dimmer. Using a dimmer not designed for low voltage electronic
applications may cause undesirable noise and potentially shorten
the life of the transformer.
Minimum volume of the electrical box must be 6 cubic inches (98
cubic centimeters).
TRANS-SFE60_-LED
Adjust the Fixture Height
1.2
This product is intended for use with LBL low voltage lighting
systems only.
Read all instructions thoroughly before beginning installation.
Important Safety Information
To reduce the risk of fire and burns, do not install this lighting
system where the uninsulated open bus bar conductors can be
shorted or contact any conductive materials.
To reduce the risk of the system overheating and possibly causing a
fire, make sure all the connections are tight.
Do not install fixture assemblies closer than 6 inches to curtains or
similarly combustible materials.
Turn the electrical power off before modifying the lighting system in
any way.
The fixtures used with the system must be identified to be used
with the corresponding system.
Minimum volume of the electrical box must be 6 cubic inches (98
cubic centimeters).
1A1A
CANOPY
1
POWER FEED
HOUSING
NOTE: It is recommended to adjust the power feed
height before installing the canopy.
(H)
Load the circuit of the surface mount transformer to no more than
the maximum rated capacity as specified.
1
The overall fixture height (H) is measured from top of the
canopy to the bottom of the power feed. Leave an additional
4” of the coaxial cable for connecting to power.
2
Once the height is determined, cut the excess coaxial cable.
1
1A1B
4”
INNER WIRE
3
COAXIAL CABLE
Strip the last 4” of the coaxial outer mesh to expose the inner
3
insulated wire.
Slide the metal sleeve down the wire to the edge of the coaxial
4
cable.
4
METAL SLEEVE
1A1C
CANOPY POST
METAL SLEEVE
6
5
M4 SET SCREW
COAXIAL CABLE
2MM ALLEN
WRENCH
5
Feed the coaxial cable up and into the canopy post.
6
Slide the metal sleeve up into the canopy post and secure by
tightening the M4 set screw with the provided 2MMAllen
wrench.
7
For dual power feed canopies: Repeat steps 1-7 for the second
power feed cable.
2