LBL Lighting LED Illum MO 2.75 Direct Feed Canopy User Manual
Installation Instructions for
980MRL2RDSPFC-LED
2” Single-Post Direct Power Feed Canopy
LED-Illuminated Monorail
GP I :ENERAL RODUCT NFORMATION
This product is suitable for indoor dry locations only.
Connect the LED-Illuminated
Install the Power Feed Canopy
1A1A
Monorail to the Power Feed Canopy
1A2A
REMOTECNPDIR2_-LED
1.1
2" ELECTRICAL BOX
2
2
1
WIRE NUT
3
SIDE
SCREWS
NOTE:The 2" electrical box should be installed prior to
these steps. Refer to the instruction provided with the 2"
electrical box.
1
Connect the two remote transformer wires to the canopy
power feed wires with wire nuts.
2
Remove the two side screws on the canopy with an Allen
wrench.
3
Attach the mounting plate to the 2” electrical box with two
#8-32 screws and reattach the canopy to the mounting plate
with the side screws.
2
MOUNTING
PLATE
CEILING
POWER FEED
HOUSING
1
POWER
FEED CAP
NOTE:The standoffs should be installed to support the
Monorail while connecting Monorail to the power feed
canopy. Refer to the instruction provided with the standoffs.
1
Remove the power feed cap from the power feed housing.
Completely back out the screw on the power feed cap.
2
2
SCREW
1
1A2B
LED-ILLUMINATED
MONORAIL
1A2C
POWER FEED
3
HOUSING
4
POWER
FEED CAP
3
Place the Monorail into the standoffs and power feed housings.
Screw the power feed cap completely to the power feed
4
housing. Make sure that the power feed cap is not cross
threaded.
POWER
FEED CAP
5
5
Tighten the screw on the power feed cap for proper power
SCREW
connection.
SAVETHESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
2
A Generation Brands CompanyA Generation Brands Company
Loading...