Installation Instructions for
980KENDP
Kendall Pendant
Pendant
GP I :ENERAL RODUCT NFORMATION
This product is suitable for damp locations.
This product can be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
L 793_P
1.0
Install the Lamp
1A
SOCKET
LAMP
CAUTION: To reduce the risk of a burn or electric
shock during relamping, disconnect the power to
the fixture.
Use Type T9 Classic EdisonMAX 75 Watt
E26 base incandescent lamp.
1
Screw the lamp into the socket.
Install the Shade
2A
1
Feed the cord, stem, socket, and lamp through the
shade.
2
Gently lower the shade until it rests properly on the
stopper.
CORD
STEM
SHADE
STOPPER
SOCKET
LAMP
1
Replace the Lamp
3A
SOCKET
SHADE
STOPPER
LAMP
CAUTION: To reduce the risk of a burn or electric
shock during relamping, disconnect the power to
the fixture.
Use Type T9 Classic EdisonMAX 75 Watt
E26 base incandescent lamp.
1
Lift the shade to expose the socket and lamp.
2
unscrew the old lamp and replace with new.
3
Gently lower the shade until it rests properly on the
stopper.
SAVETHESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
2
A Generation Brands Company