LBL Lighting Fusion Jack Canopy 7 Light Round LED User Manual
Installation Instructions for
980FSJ7PRC
7 Round Fusion Jack Canopy
Fusion Jack
GP I :ENERAL RODUCT NFORMATION
This product is suitable for indoor dry locations only.
This product can be dimmed with a standard incandescent dimmer.
Install the Canopy
CK007B-FJ_
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1.0
1A 1C
1
#8-32 SCREW
1
Remove the three #8-32 screws on the sides of the canopy
housing.
2
Lift the mounting plate from the canopy housing.
MOUNTING PLATE
2
1
CANOPY HOUSING
1
4
5
1B
MOUNTING PLATE
3
3
3
MOUNTING
PLATE HOLE
1D
5
4
ANCHOR
With a hammer tap the anchors at the marked points into the
ceiling up to the threaded portion.
Screw the anchors in the rest of the way with a Phillips
screwdriver.
5
7
7 7
7
#8-32 SCREW
5
ANCHOR
3
Align the mounting plate holes with the electrical box holes
and mark four points onto the ceiling through the mounting
holes.
6
Feed the power line wires through the mounting plate
center hole.
7
Line up the two mounting plate slots with the electrical box
holes and use the two provided #8-32 screws to mount it to
the electrical box.
1
1E 1G
8
10
8
8
#8 SCREW
8
Secure the mounting plate to the anchors with the provided
#8 screws.
1F
MOUNTING
SAFETY
BRACKET
9
SAFETY CABLE
PLATE
8
12
10
Make sure the mounting plate is grounded in accordance with
11
local electrical codes.
11
Connect the housing white wire to the neutral power line wire
with a wire nut.
12
Connect the housing black wire to the hot power line wire
with a wire nut.
9
HOUSING
9
Insert one end of the safety cable into the mounting plate
safety bracket and insert the other end into the housing safety
bracket.
Place all wires and wire nut connections properly inside
the housing.
1H
15
#8-32 SCREW
141314
Slide the housing onto the mounting plate and line up the
MOUNTING PLATE
15
CANOPY HOUSING
housing holes with the mounting plate holes.
Replace and tighten the three #8-32 screws to secure the
1415
housing in place.
15
2
Loading...