Installation Instructions for
Dimensions
Fusion Jack™
GENERAL PRODUCT INFORMATION:
This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor.
CAUTION - RISK OF FIRE
980FSJDMNSP
HS337_ 1.4
This product requires installation by a qualified electrician. Before installing be sure to read all instructions and TURN THE POWER TO THE ELECTRICAL BOX OFF.
Install the Lamp and Disk
1A
SOCKET
1
LAMP
NOTE: To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture.
Use MAX 35 Watt MR11 Front Cover Halogen
Lamp .
1Align and push the lamp pins completely into the socket holes.
1B
|
ACCESSORY SPRINGS |
LARGE HOLE 2 |
CURVED SECTION |
SECTION OF
THE CRYSTAL
GLASS DISK
|
2 |
|
CURVED |
2 |
|
2 |
||
SECTION |
||
|
2With the small hole section of the crystal glass disk facing towards lamp, place edge of the crystal glass disk into curved section of accessory springs.
CAUTION: Do not install the crystal glass disk with the large hole section of it facing towards the lamp, which will cause the crystal glass disk eventually to fall out.
NOTE: The Crystal disk must be removed when relamping.
1
Adjust the Fixture Height
2A
ALLEN WRENCH
SET SCREW
1
CONNECTOR
1Back out (do not remove) the set screw on tip of the connector with the provided Allen wrench.
2B
ALLEN WRENCH
SET SCREW
2
2Back out (do not remove) the set screw on the conical connector with the provided Allen wrench.
1C
4
3Cut the coaxial cable to the desired length.
4Gently twist the end of the coaxial cable between thumb and forefinger.
2D
SURFACE
PLATE
5Tap the conical connector on a hard surface with the set screw facing down, so the plate inside drops into place.
2E
6
CONICAL CONNECTOR
OUTER WRAPPED
WIRE STOPS HERE
6Feed and push the coaxial cable into the conical connector.The coaxial cable will come to a stop point after being inserted 3/4" into the conical connector.
2F
INNER WIRE
STOPS HERE
7
WRINKLE ON OUTER
WRAPPED WIRE
7Keep pushing the coaxial cable into the connector while rotating the connector to ease feeding the inner wire into the tip of the connector.The outer wrapped wire will start wrinkling while being inserted another 1/2" into the connector.
2G
INNER WIRE
SIGHT HOLE
8 |
9
ALLEN WRENCH
8Look into the sight hole on the top of the connector to make sure that the inner wire is contacting the end of the connector.
9Hold the coaxial cable in place and tighten the set screw on tip of the connector with the provided Allen wrench. Make sure this set screw connection is tight.
2