LBL Lighting Fusion Jack Canopy 4 Round Dome LED User Manual
Installation Instructions for
Fusion Jack 4" Round Dome Canopy
Fusion Jack™
GENERAL PRODUCT INFORMATION:
This product is suitable for indoor dry locations only.
This product can be dimmed with a standard incandescent dimmer.
LED versions are dimmable with a low-voltage electronic dimmer.
Minimum volume of the electrical box must be 6 cubic inches (98
cubic centimeters).
CK001B-FJ-_
980FSJDMC
1.4
1.4
Install the 4" Round Dome Canopy
1A 1B
1
FLAT HEAD
SCREW
1
1
Loosen the two flat head screws to remove the crossbar from
the dome canopy.
CROSSBAR
1
DOME
CANOPY
1
2
CAUTION—RISK OF FIRE
This product requires installation by a qualified
electrician. Before installing be sure to read all
instructions and DISCONNECT POWER TO THE
ELECTRICAL BOX.
CROSSBAR
#8-32 SCREW
2 2
Mount the crossbar to the electrical box with the two #8-32
screws.
1
1C
1E
3
5
TRANSFORMER
1
3
In accordance with local electrical codes, ground the crossbar
3
4
DOME
CANOPY
and transformer green wire.
4
Connect the white transformer wire to the neutral power line
wire with a wire nut.
1
5
Connect the black transformer wire to the hot power line
wire with a wire nut.
1
6
Place the transformer and all wire connections properly inside
the dome canopy.
FUSION JACK PORT
1
8
Screw the fixture Fusion Jack into the Fusion Jack port.
8
FIXTURE
FUSION JACK
SAVETHESE INSTRUCTIONS!
1D
7
FLAT HEAD SCREW
1
7
Line up the dome canopy holes with the crossbar holes.
FLAT HEAD SCREW
Replace and tighten the flat head screws to secure the dome
canopy in place.
7
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2011 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
2
A Generation Brands Company
Loading...