LBL Lighting Fusion Jack Canopy 12.75 3 Light Round LED User Manual
Installation Instructions for
980FSJ3PRC
3 Port Round Fusion Jack Canopy
Fusion Jack
GP I :ENERAL RODUCT NFORMATION
This product is suitable for indoor dry locations only.
This product can be dimmed with a standard incandescent dimmer.
Install the 3 Round Fusion Jack Canopy
1A 1C
CK003B-FJ_
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1.0
#8-32 SCREW
1 1
CANOPY HOUSING
1
Remove the three #8-32 screws on the canopy housing.
2
Lift the mounting plate from the housing.
MOUNTING PLATE
1B
3
3
3
MOUNTING PLATE
3
4
ANCHOR
4
With a hammer tap the anchors at the marked points into the
ceiling up to the threaded portion.
5
Screw the anchors in the rest of the way with a Phillips
screwdriver.
5
1D
#8-32 SCREW
7
7
MOUNTING PLATE
3
Align the mounting plate slots with the electrical box holes and
mark four points onto the ceiling through the mounting holes.
6
Feed the power line wires through the mounting plate
center hole.
7
Line up the two mounting plate slots with the electrical box
holes and use the two provided #8-32 screws to mount it to
the electrical box.
1
1E 1H
#8 SCREW
8
8
Secure the mounting plate to the four anchors with the four
8
8
8
provided #8 screws.
1F
MOUNTING PLATE
SAFETY BRACKET
9
SAFETY CABLE
9
15
13
Place all wires and wire nut connections properly inside
the housing.
14
14
Slide the housing onto the mounting plate and line up the
housing holes with the mounting plate holes.
15
15
Replace and tighten the three #8-32 screws to secure the
housing in place.
1I
15
HOUSING
9
Insert one end of the safety cable into the mounting plate
safety bracket and insert the other end into the housing safety
bracket.
1G
12
10
10
Make sure the mounting plate is grounded in accordance with
local electrical codes.
11
Connect the housing white wire to the neutral power line wire
with a wire nut.
12
Connect the housing black wire to the hot power line wire
with a wire nut.
11
16 16 16
CAUTION: load perRISK OF FIRE. Maximum
port is watt.75 Do Not Overload!
16
Screw each fixture Fusion Jack completely into one Fusion Jack
port.
151417
Turn the power on.
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2008 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
2
Loading...