LBL Lighting East River S User Manual
Installation Instructions for
980ERIVERS
East River Suspension
Suspension
GP I :ENERAL RODUCT NFORMATION
This product is suitable for damp locations.
This product may be dimmed with a low-voltage electronic dimmer.
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
SU770_
1.0
Install the Mounting Plate
1A
1B
ALLEN
WRENCH
MOUNTING
PLATE SCREW
1
With the Allen wrench provided, separate the mounting
plate from the canopy by removing all four mounting
plate screws.
MOUNTING PLATE
CANOPY
MOUNTING
PLATE SCREW
1C
#8-32 SCREW
#8-32 SCREW
MOUNTING
PLATE
3
Secure the mounting plate to the electrical box with the
two #8-32 screws provided.
2
Remove the mounting plate from the canopy.
1
Assemble the Fixture
Adjust the Power Cord
2A
3
1
CABLE
CLUTCH
POWER
CORD
3A
1
Take note of the wire connections and remove the wire
POWER CORD WIRE
DRIVER WIRE
nuts to disconnect the power cord wires from the driver
AIRCRAFT
CABLE
wires.
3B
4
NOTE: Make sure to support the fixture while
adjusting the aircraft cables. An assistant is
recommended to complete the remaining steps.
1
Feed the aircraft cables through the cable clutches in
the canopy.
2
Evenly pull the aircraft cable up through the canopy to
raise the fixture to the desired length.
3
Cut off the excess aircraft cable leaving enough for fine
leveling later.
CORD
SCREW
2
7
3
POWER
CORD
NOTE: The power cord does not support the fixture.
For a casual “lazy cord” look, cut the power cord
several inches longer that the drop height of the
fixture.
2
Loosen the cord screw.
3
Pull the power cord through the canopy until it reaches
the length desired.
4
Leave 6 inches of cord behind the canopy and cut off
extra cord.
2
Loading...