LBL Lighting Duke Grande User Manual
Installation Instructions for
Duke and Duke Grande
Suspension
GP I :ENERAL RODUCT NFORMATION
This product is suitable for damp locations.
This product can be dimmed with a low-voltage electronic dimmer.
980DUKES
EF667_LED
SU756_LED
1.1
This product requires installation by a qualified
electrician. Before installing be sure to read all
instructions and TURNTHE POWER TO THE
ELECTRICAL BOX OFF.
CAUTION - RISK OF FIRE
Assemble the Fixture
1A 1B
FIXTURE SCREWS
FIXTURE FRAME
FIXTURE FRAME
1
Ensure that all 3 fixture screws are completely backed
out.
GLASS SHADE
2
Place the fixture frame on the glass shade and line up
the three mounting holes.
Completely screw in the three fixture screws.
3
1
Preparing the Canopy
Install the fixture
2A
CANOPY
1
Remove the cross bar from the assembly by
unscrewing the two thumb nuts.
2B
CROSSBAR
THUMB NUTTHUMB NUT
ELECTRICAL
BOX
Note : If shortening the power cord, take note of the
fixture’s wire connection configuration before
removing the wire nuts. The same connection to
driver is necessary for the fixture to work correctly.
NOTE: Make sure to support the fixture while
adjusting the aircraft cables. An assistant is
recommended to complete the remaining steps.
3A
STRAIN RELIEF
3
CABLE
CLUTCH
21
Feed the aircraft cables through the cable clutches in
1
4
POWER CORD
SET
SCREW
the canopy.
2
2
Evenly pull the aircraft cables up through the canopy to
raise the fixture to the desired length.
CANOPY
AIRCRAFT
CABLE
2 2
#8-32 SCREW #8-32 SCREW
CROSSBAR
2
Mount the crossbar to the electrical box with the two
#8-32 screws.
Cut off the excess aircraft cable leaving enough for fine
2
3
leveling later.
4
2
If necessary loosen the set screw in the strain relief and
feed the power cord from the fixture into the canopy
port.
3B
5
CORD
NOTE: The power cord does not support the fixture.
For a casual “lazy cord” look, cut the power cord
several inches longer that the drop height of the
fixture.
25
Once the desired look is determined, tighten the set
screw on the strain relief.
Mark the cord underneath the strain relief.
26
2
Loading...