LBL Lighting Dual-Post Direct Power feed Canopy User Manual
Installation Instructions for
980MRL2RDDPFC
2” Dual-Post Direct Power Feed Canopy
Monorail
GENERAL PRODUCT INFORMATION:
This product is suitable for indoor dry locations only.
Install the Power Feed Canopy
1A
2" ELECTRICAL BOX
WIRE NUT
SIDE
SCREWS
HOT 1
COM 1
1
2
4
3
2
6
5
HOT 2
COM 2
MOUNTING
PLATE
CEILING
Install the Monorail to the Power
Feed Canopy
2A
MONORAIL
M3 SET SCREW
REMOTECNPDIRDF2_
STRAIGHT ISOLATING CONNECTOR
1
2
1.6 MM ALLEN
WRENCH
1.1
MONORAIL
NOTE:The 2" electrical box should be installed prior to
these steps. Refer to the instruction provided with the 2"
electrical box.
Starting with one post, connect the center wire to the conduit
1
wire marked "HOT 1" with a wire nut.
2
Connect the side wire to the conduit wire marked "COM 1"
with a wire nut.This post will power one feed of the
MonoRail.
3
Connect the center wire of the other post to the conduit
wire marked "HOT 2" with a wire nut.
4
Connect the side wire to the conduit wire marked "COM 2"
with a wire nut.This post will power the other feed of the
MonoRail.
5
Remove the two side screws on the canopy with an Allen
wrench.
6
Attach the mounting plate to the 2” electrical box with two
#8-32 screws and reattach the canopy to the mounting plate
with the side screws.
Push two Monorail sections completely onto the straight
1
isolating connectors.
2
Tighten the M3 set screws firmly with the provided 1.6 MM
Allen wrench. the set screws which
may strip the thread.
Do Not Over Tighten
1
2B
2C
POWER FEED
HOUSING
3
POWER
FEED CAP
4
SCREW
NOTE:The standoffs should be installed to support the
Monorails while connecting Monorails to the power feed
canopy. Refer to the instruction provided with the
standoffs.
3
Remove the power feed caps from the power feed housings.
4
Completely back out the screw on the power feed caps.
5
6
POWER FEED CAP
7
STRAIGHT ISOLATING CONNECTOR
SCREW
NOTE: It is recommended that two people install the
Monorail sections to the standoff and power feed
housings.
Place the combined Monorail sections into the standoffs and
5
power feed housings so that the straight isolating connector
section is located in the middle of the two power feed
housings.
Make sure that the Monorail sections are
electrically isolated from each other.
Screw the power feed caps completely to the power feed
6
housings.
Make sure that the power feed caps are not cross
threaded.
7
Tighten the screw on the power feed caps for proper power
connection.
SAVETHESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2008 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
2
A Generation Brands Company
Loading...