Page 1
Installation Instructions for
980DERBYWD
Derby Wall (LED)
WALL
GENERAL PRODUCT INFORMATION:
This product is suitable for damp locations.
This product can mount either to a 4” square electrical box with a
round plaster ring or an octagon electrical box.
This product can be dimmed with a low-voltage electronic dimmer.
This instruction shows a typical installation.
CAUTION - RISK OF FIRE
This product requires installation by a qualified
electrician. Before installing be sure to read all
instructions and TURNTHE POWER TO THE
ELECTRICAL BOX OFF.
LW666_LED
1.0
Install the Fixture
1A
MOUNTING
PLATE
SCREW
MOUNTING
PLATE
SCREW
1B
THUMB SCREW
LED PLATE
MOUNTING
PLATE
THUMB SCREW
1
Remove the two mounting plate screws located on top
and the bottom of the fixture.
2
Remove the mounting plate.
To gain access to the mounting plate holes, remove the
63
two thumb screw to temporarily loosen the plate
holding the LED lamp.
1
Page 2
1C
DRIVER
6
5
4
Connect the mounting plate ground wire to a suitable
64
ground in accordance to local electrical codes.
Connect the white driver wire to the neutral power line
65
wire with a wire nut.
66
Connect the black driver wire to the hot power line wire
with a wire nut.
1D
8 8
#8-32 SCREW
7
Properly place all wire, wire nut connections, and the
driver inside the electrical box.
8
Attach the mounting plate to the electrical box using
the two #8-32 screws provided.
1E
THUMB SCREW
LED PLATE
THUMB SCREW
Re-install the LED Plate and secure it tightly with the
69
two thumb screws.
2
Page 3
1F
ANCHOR
1H
MOUNTING
PLATE
SCREW
ANCHOR ANCHOR
10
Verify that the mounting plate is level before continuing.
11
Line up an anchor tip with the center of the mounting
plate hole and push the anchor into the wall up to the
threads.
612
Screw the anchor in the rest of the way.
Repeat steps 4-6 for the other anchors.
613
1G
SCREW
WASHER
MOUNTING
PLATE
SCREW
16
Replace the shade onto the mounting plate and reinstall
the two mounting plate screws. Tighten to secure.
WASHER
SCREW
Slide a #8 screw through a washer and screw it into an
614
WASHER
SCREW
anchor.
615
Repeat for the other anchors to secure the mounting
plate to the wall.
3
Page 4
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2012 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
4
A Generation Brands Company
Loading...