LBL Lighting Constellation Grande S User Manual
Installation Instructions for
980CONSTGS
Constellation Grande
Suspension
GP I :ENERAL RODUCT NFORMATION
This product is suitable for damp locations.
This product can be dimmed with a standard incandescent dimmer.
CAUTION - RISK OF FIRE
This product requires installation by a qualified
electrician. Before installing be sure to read all
instructions and TURNTHE POWER TO THE
ELECTRICAL BOX OFF.
LP747_
1.0
Preparing for Installation
1A
CANOPY
1
Remove the crossbar from the canopy by completely
unscrewing the strain relief.
1B
CROSSBAR
2 2
STRAIN RELIEF
CROSSBAR
#8-32
SCREW
1C
SET SCREW
3
Loosen the set screw on the strain relief.(Do Not Remove)
1D
BRACKET
CAP
COVER
2
Mount the crossbar assembly to the electrical box with
the two provided #8-32 screws.
SOCKET
4
Disassemble the socket assembly by unscrewing the cap
and separating the socket, bracket, and the cover.
1
Assemble the Fixture
2A
21
Loosen the two set screws on the stopper at the bottom
SHADE
4
5
AIRCRAFT
CABLE
RUBBER
GROMMET
STOPPER
3
of the cable post aircraft cable using the provided Allen
wrench.
22
Determine the desired height of the fixture, move the
stopper to the determined location, and tighten the two
set screws on the stopper. Take note of theNOTE:
height measurement, it will be needed for the canopy
aircraft cable.
23
Cut off the excess aircraft cable.
SET SCREW
2C
CUSHION
PAD
7
7
Place the socket assembly inside the shade.
28
Ensure that the cushion pads are in place and insert the
8
BRACKET
SOCKET
ASSEMBLY
bracket into the shade by slightly rotating it into place.
2D
CAP
COVER
10
NIPPLE
SHADE
24
Ensure that the rubber grommet is in place and install
the separate aircraft cable into the shade.
25
Feed the open end through the small hole in the shade
and pull it all the way through until the stopper is
reached.
2B
SOCKET
LAMP
CAUTION:To reduce the risk of a burn or electric shock
during relamping, disconnect the power to the fixture.
BRACKET
29
Place the socket nipple through the bracket hole and
pull the assembly up until it rests inside the top of the
shade.
210
Place the cover over the top of the shade opening lip,
ensure that the bracket is centered and is gripping the
shade properly, and secure it all by screwing on and
tightening the cap.
Use MAX 75 Watt type A19
medium base incandescent lamp.
1
6
Screw the lamp into the socket.
2
2E
POWER CORD
STRAIN RELIEF
13
CANOPY
CABLE
CLUTCH
AIRCRAFT
CABLE
11
Feed the aircraft cable through the cable clutch in the
11
14
SET
SCREW
canopy.
212
Pull the aircraft cable up through the canopy to raise
the fixture to the determined length.
Cut off the excess aircraft cable leaving enough for fine
2
13
leveling later.
14
2
If necessary loosen the set screw in the strain relief and
feed the power cord from the fixture into the canopy
port.
2F
15
CORD
NOTE: The power cord does not support the fixture.
For a casual “lazy cord” look, cut the power cord
several inches longer that the drop height of the
fixture.
2
15
Once the desired look is determined, tighten the set
screw on the strain relief.
16
2
Mark the cord underneath the strain relief.
3
Loading...