Installation Instructions for
980CASIN1W
Casino Wall
Wall
GP I :ENERAL RODUCT NFORMATION
This product can mount to either a 4" square electrical box with
round plaster ring or an octagon electrical box.
This product is suitable for damp locations.
This product can be dimmed with a standard incandescent dimmer.
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
HW310_2G60
1.5
Install the Fixture
1A 1B
#8-32 SCREW
CROSSBAR
ASSEMBLY
CANOPY
1
1
1
Remove the two #8-32 Phillips head screws on side of the
canopy.
2
3
REAR CROSSBAR
#8-32 SCREW
3
FRONT
CROSSBAR
NOTE:To mount the crossbar assembly, use the front
crossbar, with the electrical box containing a plaster ring,
or use the rear crossbar, with the octagon electrical box.
Mount the crossbar assembly to the electrical box holes with
the two #8-32 screws provided.
3
ELECTRICAL BOX HOLE
2
Remove the crossbar assembly.
1
1C
1D
#8-32 SCREW
5
4
6
4
Connect the crossbar assembly to a suitable ground in
accordance with local electrical codes.
5
Connect the fixture white wire to the neutral power line wire
with a wire nut.
6
Connect the fixture black wire to the hot power line wire with
a wire nut.
8
7
Place all wires and wire nut connections properly inside the
8
electrical box.
8
Place the fixture canopy onto the crossbar assembly. Level the
fixture vertically; replace and tighten the two #8-32 Phillips
head screws.
2