LBL Lighting Bare Swivel II User Manual
Installation Instructions for
980FSJBRHDSII
Bare Head Swivel II
Fusion Jack™
GP I :ENERAL RODUCT NFORMATION
This product is ETL listed and suitable only for indoor dry locations
and approved for use at any height above the finished floor.
WARNING: Risk of Fire. Hot Surface. Install the fixture
at least 6" (Inches) away from wall, curtains and combustible
materials. Maintain at least 9" (Inches) of clearance directly in
front of the fixture.
AVERTISSEMENT: Risque du feu. Surface Chaude.
Installez le montage au moins 6" (Pouces), 153 mm, loin du
mur, des rideaux et des matériaux combustibles. Maintenez au
moins 9" (Pouces), 230 mm, de dégagement directement
devant le montage.
HAMR16_1A50FSJ
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1.2
Install the Lamp
1A
SOCKET
LAMP
NOTE:To reduce the risk of a burn or electric shock
during relamping, disconnect the power to the fixture.
MAX 50
Use Watt MR16 Front Cover
Halogen Lamp.
1B
2
3
3
SPRING
3
Insert the two springs into the socket assembly holes.
SOCKET ASSEMBLY
1
Align the lamp pins with socket holes.
2
Push the lamp pins completely into the socket holes.
1
1C
4
SPRING
LAMP FRONT
4
Gently pull the springs with thumb and forefinger,and hook the
4
4
ends onto lamp front so that they hold the lamp in position.
SAVETHESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
2
A Generation Brands Company
Loading...