LBL Lighting Bare Swivel I User Manual

Installation Instructions for
980FSJBRHDSI
Bare Head Swivel I
Fusion Jack
GP I :ENERAL RODUCT NFORMATION
This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor.
Colored and Dichroic lenses, Diffuser and Spread lenses or Structure louver or Lenseless Clips and Flite paper MR16 are the compatible accessories.
WARNING: Risk of Fire. Hot Surface. Install the fixture
at least 6" (Inches) away from wall, curtains and combustible materials. Maintain at least 9" (Inches) of clearance directly in front of the fixture.
AVERTISSEMENT: Risque du feu. Surface Chaude.
Installez le montage au moins 6" (Pouces), 153 mm, loin du mur, des rideaux et des matériaux combustibles. Maintenez au moins 9" (Pouces), 230 mm, de dégagement directement devant le montage.
HBMR16_1A50FSJ
CAUTION - RISK OF FIRE
This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
Use minimum 90°c supply conductors.
1.3
Install the Lamp
1A
SOCKET
LAMP
NOTE:To reduce the risk of a burn or electric shock
during relamping, disconnect the power to the fixture.
MAX 50
Use Watt MR16 Front Cover Halogen Lamp.
1
Align the lamp pins with socket holes.
2
Push the lamp pins completely into the socket holes.
2
SOCKET
3
TA B
4
3
Hook one of accessory (optional) tabs onto edge of the MR16 lamp.
4
Snap the other accessory tab onto opposite edge of the MR16 lamp.
LAMP
ACCESSORY (OPTIONAL)
1
SAVETHESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved. The "LBL Lighting" graphic is a registered trademark of LBL Lighting. LBL Lighting reserves the right to change specifications for product improvements without notification.
2
A Generation Brands Company
Loading...