Lawmate WCH-250X Operation Manuals
Names and Parts
(1) (2)
Wireless Camera Hunter Operation
Manual
WCH-250X
V1.0
Law Enforcement Products Manufacturer
LawMate
LCM Operation Interface
(3)
■
Enter setting:
Slide the POWER key on side of the unit to turn on the device, press and hold the
SETUP key for 3 seconds then release it. The icon will be blinking on the LCM (the
smaller screen), scroll the SETUP key upward or downward to change setting.
■
Change setting:
Press the SETUP key once to confirm change and to move on next setting.
■
Exit setting:
Press and hold the SETUP key again for 3 seconds.The device will return to scanning mode.
UP
PUSH
DOWN
67.0 0 mm
96.00 mm
21.2 0 mm
1.2GHz ant. mount
2.4 & 5.8GHz ant. mount
SETUP key
LCD screen
LCM screen
Signal In/Out socket
DC 5V In
Power Switch
■
Installing the battery
Remove battery cover on back of the
unit. Slide the supplied battery at
about 15 degree angle to the battery
compartment. Please be aware of +/direction.
■
Charging the battery:
Connect the supplied power adaptor to an AC wall outlet and attached the other end
of the cord to the DC 5V In socket.
■
Power indication:
When charging the battery, a red color LED light will illuminate. Once the battery is
fully charged, the LED light will turn off. (The charging time is approximately 3 ~ 4
hours depending on the battery remaining power.) Please charge the battery for 8
hours on the first-time use.
■
Antenna connector
Plug antenna 1 to port 1 and antenna 2 to port 2. You can
find the indication printed on the antennas as well as on
the ports. Turn the antenna’s base clockwise until it locks
into place.
■
Power switch:
The power switch is on the side of the device. When the unit is turned on, it starts
scanning the signal automatically. Make sure the antenna is screwed tightly to its
allocated position to avoid poor reception.
■
Frequency scanning:
Whenever a wireless A/V signal is detected, the image will be displayed on the
screen and stays for few seconds. The length of time depends on your setting. You
have the option to lock the channel by scroll upward or downward the SETUP key on
side of the device to lock the channel or else it will pass on and continue scanning.
■
Manual scanning:
Scroll upward or downward the SETUP key to scan manually.
■
Low battery alert:
When the battery gets low, the battery icon will blink. Charge your battery immediately.
■
External video input:
To connect external video to the device, change the setting to EX mode. Make sure
the connector is plugged properly to the Signal In/Out socket on side of the device,
otherwise it will result non-signal input.
1
2
EX
60
30
30
30
30
4
2
60
30
30
2
MH
M
B
MH
MH
M
ML
L
UH
B
30
30
30
30
30
30
30
1080
00
1080
30
1080
30
UH
1080
2
B
30
a
00
Signal Dwell
Time
EXT. AV input mode
30 Sec. interval mode
60 sec. interval mode
Standard scanning mode
8 seconds
4 seconds
2 seconds
L (Low/-20dBm)
ML (Medium Low
/-30 dBm)
H (High/-60dBm)
MH (Medium High
/-50dBm)
M (Medium/-40dBm)
UH (Ultra High
/ -75dBm)
Alert on/Vibrate Off
Alert on/Vibrate On
Alert Off/Vibrate Off
Alert Off/Vibrate On
Scanning
Mode
Receiver
Sensitivity
Audio & Vibration
Alert Setting
00
Loading...