Lawmate PV-500 ECO User Manual
CHAPTER 01 OVERVIEW 02
02 FUNCTION MODES 05
03 BASIC OPERATION 06
04 INTRODUCTION OF ALL SETTING FUNCTIONS 11
05 VIDEO PLAYBACK 22
06 VIDEO EDITING 25
07 PHOTO BROWSING 26
08 PHOTO EDITING MODE 27
09 SUPPORTED IMAGE FILE FORMAT 29
10 RECORD 30
11 REMOTE CONTROLLER 35
12 SUPPORTED VIDEO FILE FORMAT 36
13 SPECIFICATIONS 37
14 IMPORTANT 38
15 NOTE 40
PV-500 ECO User Manual
01
TABLE OF CONTENT
02
Overview
PV-500ECO
PV-500 ECO User Manual
03
Overview
Remote control
IR remote controller is required to get access to all the applications of PV-500ECO.
PV-500 ECO User Manual
04
Overview
Accessories
PV-500 ECO User Manual
05
Function Modes
Video file playback
Browse images and picture
External video source recording
Functions setting
PV-500 ECO User Manual
06
Basic operation
Turn on/ off of PV-500 EVO player
To Do this
Turn On
Press the Power On/ Off button about 1 sec.
on PV-500ECO to turn on the power and the
greeting screen will appear.
Turn Off
Press the Power On/Off button about 1sec.
on PV-500ECO, or press the Power button on
the remote control to turn off PV-500ECO.
Using IR remote controller
Use IR remote controller to get started for all the applications of PV500ECO device.
● Press ESC button to return tolast page or return back to main menu.
● Press / to the last or next item
● In the sub-menu bar of or , press / to the last or next item.
● Press to play or enter the item that chosen.
● Press / / / to choose each function on the main menu.
PV-500 ECO User Manual
07
Basic operation
Adjust Volume
While playing Video or in the Microphone setting mode, press the volume button in the remote controller to adjust volume.
● Volume varies in 10 steps.
● Volume status will be displayed on the left–down side of screen.
PV-500 ECO User Manual
REC Button
Use IR remote controller to get started for all the applications of PV500ECO device.
● Start Recording: Press REC button on the remote controller to start recording.
● Stop Recording: Press PAUSE button on the remote controller to pause/stop recording, and
the screen will return to stand-by mode of Preview to prepare for recording.
SETUP Button
In each function mode, Press SETUP Button for its settings .
Basic operation
Link with other equipments
● External Video Source Recording– Cam in
Plug an external camera into Cam-in , it enable recording.
● Output to TV Screen:
Plug an RCA cable in AV-out to have the image output to the TV.
Precaution:
Check “Setup” Menu, the setting of “Display” must be set from “LCD” into “TV” enable image output.
PV-500 ECO User Manual
08
09
Basic operation
● Connect to wire controller:
Plug an RCA cable in AV-out to have the image output to the TV.
● Connect to PC:
1. Connect the two ends of A/B type of USB cable to PV-500ECO and PC.
2. An indication for “USB Mode” appears on the screen for 5 seconds after the link is properly installed.
PV-500 ECO User Manual
10
Basic operation
Precaution: The LED light will be turned off after finishing charging; to keep long life-span of the battery, the power supply should be
PV-500 ECO User Manual
● Charging:
When the power goes down, power LED indictor blinks (green) and the meter with no bars displays on the bottom right corner of the
screen, which indicates that the power of the host exhausts; please recharge it immediately. connect the main device with the
power supply and then plug the power supply into the electrical outlet. The LED light will be on Orange.
BATTERY MODE
SUPPLY MODE
11
Introduction to all Setting Functions
● Resolution (1280*960/1280*720/1024*768/720*480//640*480/320*240)
● Quality (High/Normal/Low)
● Frame Rate( 1 / 5/ 15 /20/25)
● Audio (Enable/Disable)
● Frame Counter Stamp (On/Off)
● Timestamp (On/Off)
● Device ID Stamp (On/Off)
● Display (LCD/TV/Both)
● Microphone sensitivity
● Over-write
In the MAIN MENU mode, press SETUP button on the remote controller to enter the SETTINGS mode; Press
ESC button to escape Setting Mode.
01. Preview >
● Press on Preview to start setting each function as below.
● In sub-menu, Press / to enter the last or next item/page; Press to finish the selection.
Notice: For TV output, it is needed to select Display to TV or Both.
PV-500 ECO User Manual
12
Introduction to all Setting Functions
02. Pre-event >
Press on Pre-event to start setting each function as below.
● Resolution (1280*960/1280*720/1024*768/720*480/640*480/320*240)
● Quality (High/Normal/Low)
● Frame Rate ( 1 / 5/ 15 /20/25)
● Audio (Enable/ Unable)
● Frame Counter Stamp (On/Off)
● Timestamp (On/Off)
● Device ID Stamp (ON/Off)
● Display (LCD/TV/BOTH)
● Pre-Record Time (30 sec/15 sec)
● Microphone sensitivity
● Over-write (Disable/Enable)
PV-500 ECO User Manual
Loading...